This is a genuine manufacturer sourced replacement part used on Waring blenders. It helps to distribute the pressure evenly and provides a tight seal for the bearing holder. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these se...Read moreals and washers will become brittle and compressed, then will have to be replaced. For proper application please refer to diagrams of your unit. This part is made out of rubber material and it is sold individually. To complete this repair you will need a wrench.
This is an original part from Waring. The blade is designed for use with several blender devices. The food cutting blade is fastened between the bearing cap and the cap nut. This component is sold individually, and no tools should be needed for the replacement.
This is a genuine Waring Pro Part. This Jar Pad is used on many models of Waring blenders. The Pad is used to cushion the blender jar and to keep it in place while blending. Four Pads are needed on every model of blender. These Pads are made of a dense rubber and should be replaced if they tear or have worn to the point of not being able to support the blender jar evenly while blending.
Leaks, grinding noise, or looseness around the cutter assembly may indicate worn internal parts. This flat washer supports proper spacing in the blade-bearing stack on compatible blender models. Because several similar washers and seals may be used in the same area, confirm the exact location with the model diagram before ordering. Discon...Read morenect power and remove the jar from the base before service. Check the bearing, cap, and seals for damage, then tighten the assembly evenly without crushing the washer.
This is a genuine manufacturer sourced replacement part used on Waring blenders. It helps to distribute the pressure evenly and provides a tight seal for the bearing holder. For proper application please refer to diagrams of your unit. This part is made out of metal and it is sold individually.
It is a genuine OEM supplied replacement hardware that is specially produced for Waring blenders. This is the hex nut that is secured on the bottom of the blender jar. Please note one durable metal item is included per order.
This is an authentic Waring replacement part that has been sourced from the original manufacturer and is intended to be used with blenders. The metal bearing holder is used to support the motor's spindle shaft. This item is sold as an individual replacement part.