35BL33 (707SB) Waring Blender - Overview

This is a genuine manufacturer approved replacement part designed for use on Waring blenders. This item fills the center hole in the outer lid. It is made out of clear plastic and it is sold individually.

This is a genuine manufacturer sourced replacement part used on Waring blenders. It helps to distribute the pressure evenly and provides a tight seal for the bearing holder. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these se...Read moreals and washers will become brittle and compressed, then will have to be replaced. For proper application please refer to diagrams of your unit. This part is made out of rubber material and it is sold individually. To complete this repair you will need a wrench.

Genuine Waring replacement part, this item is sold individually. This part acts as a seal for the blenders shown below. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these seals and washers will become brittle and compressed, then will have to be replaced.

This is an authentic manufacturer sourced replacement part used on Waring blenders. Jar assembly locks into the blender base and holds the foods and liquids being blended. This container is made out of glass and it is sold individually.

This is an original part from Waring. The blade is designed for use with several blender devices. The food cutting blade is fastened between the bearing cap and the cap nut. This component is sold individually, and no tools should be needed for the replacement.

This is a genuine Waring Pro Part. This Jar Pad is used on many models of Waring blenders. The Pad is used to cushion the blender jar and to keep it in place while blending. Four Pads are needed on every model of blender. These Pads are made of a dense rubber and should be replaced if they tear or have worn to the point of not being able to support the blender jar evenly while blending.