358796170 Craftsman Edger - Overview

The Fuel Cap with retainer, often simply known just as the fuel cap, keeps fuel from splashing out of your tank and debris from entering it. Black in color, it is sold individually and made of plastic. Because of everyday fatigue and wear, the cap can become damaged over time and must be replaced. You will know if it is time to replace ...Read moreyour fuel cap if you notice visible damage or experience fuel leaking from it. You can make this repair by hand, just attach the cap directly back onto the fuel tank. Most of our customers found this repair very easy.

The chainsaw starter rope is a three-foot-long white rope that is approved by the original equipment manufacturer, and which wraps around the recoil pulley and is pulled to start the engine. Installation is rated as "Easy" by customers and requires a screw driver, pliers, and torx screwdriver. If the rope breaks it should be replaced. Ref...Read moreer to your make, model and diagram to ensure this rope is right for your machine.

This check valve, also known as a one-way valve, is a genuine OEM part that regulates the flow of fuel/oil in the equipment engine to prevent it from flowing backwards. It is made of plastic and designed for use in a variety of lawn and garden power equipment. If the valve is jammed, worn down, or contaminated with dirt and debris, it wil...Read morel be unable to open and close properly, thus restricting the flow of fuel and compromising the engine combustion process. You will likely notice fuel leaks around the carburetor, engine stalling, hard starting, and overall lower performance from your equipment. To remove the faulty valve, carefully disconnect any hoses or fasteners connected to it. Place the new valve in position and secure it appropriately.

This is an original replacement part manufactured for use with chainsaws and leaf blowers. The washer is commonly used to disperse the pressure put on the flywheel by a nut across a wider surface area. This washer is available as an individual replacement part, please see model diagram for associative parts.

It is a genuine item that is supplied by the original equipment manufacturer for handheld lawn and garden equipment. The wrist pin retainer is an important component which helps to secure the piston pin. If the part is missing or is damaged, this will provide an identical replacement for the original component that was installed on a new ...Read moreunit. Note, this high-quality wrist pin retainer is made of durable metal and is sold as an individual item. Keep in mind, the pin is all sold separately. A screwdriver, a wrench set, and pliers will be needed to perform this repair. To ensure the correct replacement procedure, refer to the appropriate diagrams for your model.

A genuine item which is supplied directly from the original equipment manufacturer for use with handheld lawn and garden equipment. The purpose of a washer is to provide a tight seal between connected parts, make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality component is made of durable metal and is sold individually.

It is a genuine manufacturer-sourced replacement part which is specially produced for use with Weed Eater and Poulan gas powered trimmers. This is a special fitting which allows two fuel lines to be connected, over time it may get damaged or simply lost eventually requiring a replacement. It is a high-quality component which is made of durable plastic material and it is sold individually.

It is an authentic OEM replacement air filter that is specially designed for use with handheld lawn and garden equipment. This foam filter helps to ensure the air that goes into the engine is free of dust and other contaminants. Please note this high quality item is sold individually.

This is a genuine replacement part sourced from the original manufacturer for use with outdoor power equipment. The hex socket head screw is used with several different types of machines and the application of the screw can vary based on the model of equipment. This screw is sold individually.