This is the Genuine Craftsman replacement part. It is made out of Flexible Rubber and is Sold Individually. The purpose of the 530069216 Tank Purge Line is to return the excess fuel that is in the carburetor after the primer bulb has been pushed. The excess fuel is forced through the purge line back into the fuel tank. Over time the Tank Purge Line will become brittle and crack and will need to be replaced.
The chainsaw starter rope is a three-foot-long white rope that is approved by the original equipment manufacturer, and which wraps around the recoil pulley and is pulled to start the engine. Installation is rated as "Easy" by customers and requires a screw driver, pliers, and torx screwdriver. If the rope breaks it should be replaced. Ref...Read moreer to your make, model and diagram to ensure this rope is right for your machine.
This bar adjusting pin hooks onto the crankcase along with the bar adjust retainer and the screw. When you tighten the screw it helps to place tension on the bar. This high-quality pin is made out of metal and is sold individually. It is an authentic OEM sourced item which is specially produced for use with Poulan chainsaws. A screwdriver and a socket set may be needed when replacing this part.
This is a genuine manufacturer-sourced replacement part, it is specially designed for use with Poulan and Husqvarna chainsaws. It is a standard hardware which has multiple applications depending on the model of your unit, please make sure to check appropriate diagrams for correct location and use of this hardware. Please note this durable metal nut is sold individually.
This authentic item is supplied directly from the original equipment manufacturer for use with Poulan chainsaws. It is an identical replacement for a missing or a damaged screw that was installed on a new unit. The part is an important component of the bar adjusting mechanism. Make sure to check the appropriate diagrams of your model for ...Read morethe correct location and application of this hardware. Keep in mind this high-quality screw is made of durable metal and is sold individually. A screwdriver will be needed to perform this repair.
This item is an authentic Ridgid kit-carb that has been sourced from the original manufacturer to be used with chainsaws. Over time due to regular use parts tend to wear out and they may begin to fail eventually requiring replacements to ensure your tool functions properly. This kit includes all the recommended component to be replaced wh...Read moreen repairing your carburetor. To ensure the proper procedure, refer to the owner's manual and the diagrams for your model. A screwdriver, a wrench set, and pliers might be needed to replace these components.
A replacement inlet valve component used in small two-stroke and handheld engine applications to regulate intake flow; manufactured to OEM tolerances for correct fit and consistent engine performance.