This Genuine OEM fuel filter is designed to maintain the performance and longevity of your equipment by preventing dirt and debris from entering the carburetor. Located inside the fuel tank, this essential component ensures clean fuel delivery, protecting the engine from potential damage caused by contaminants. Sold individually, the filt...Read moreer is built to meet original equipment standards for fit and function. Over time, the filter may become clogged, restricting fuel flow and making engine starts more difficult. For optimal performance, it should be replaced—not cleaned—at the first sign of blockage or wear.
This is the Genuine Craftsman replacement part. It is made out of Flexible Rubber and is Sold Individually. The purpose of the 530069216 Tank Purge Line is to return the excess fuel that is in the carburetor after the primer bulb has been pushed. The excess fuel is forced through the purge line back into the fuel tank. Over time the Tank Purge Line will become brittle and crack and will need to be replaced.
This is a genuine OEM replacement clutch drum that is specially manufactured for Poulan and Husqvarna chainsaws. This is the piece beneath the clutch that actually drives the chain. When it wears down, your saw will see a major decrease in performance. A common issue with the clutch drum is erosion of the spindle where the upper drive sha...Read moreft connects to the assembly. The square corners of the spindle become rounded causing the shaft disengage.It is a high quality metal item that is sold individually.
This metering diaphragm is an original part for use in edgers, blowers, trimmers, and chainsaws made by Poulan, Paramount, Weed Eater, Husqvarna, and Jonsered. It fits between the metering diaphragm gasket and the metering diaphragm cover. It is made of a thin material and will need to be replaced if it breaks. A screwdriver may be needed when replacing this part and keep in mind that it is sold individually.
This is an original replacement part manufactured for use with chainsaws and leaf blowers. The washer is commonly used to disperse the pressure put on the flywheel by a nut across a wider surface area. This washer is available as an individual replacement part, please see model diagram for associative parts.
It is a genuine item that is supplied by the original equipment manufacturer for handheld lawn and garden equipment. The wrist pin retainer is an important component which helps to secure the piston pin. If the part is missing or is damaged, this will provide an identical replacement for the original component that was installed on a new ...Read moreunit. Note, this high-quality wrist pin retainer is made of durable metal and is sold as an individual item. Keep in mind, the pin is all sold separately. A screwdriver, a wrench set, and pliers will be needed to perform this repair. To ensure the correct replacement procedure, refer to the appropriate diagrams for your model.
A replacement inlet valve component used in small two-stroke and handheld engine applications to regulate intake flow; manufactured to OEM tolerances for correct fit and consistent engine performance.
This is a special spacer that provides a tight fit for the clutch. Over time it may wear out, get damaged or lost eventually requiring a replacement. To ensure the proper repair procedure, check the owner's manual and the parts diagrams for your specific model. This high-quality clutch spacer is made of durable metal and is sold as an ind...Read moreividual item. It is a genuine manufacturer-supplied item that is made for Poulan and Husqvarna chainsaws.
This is sold as a set that contains eight washers. These parts attach to the tank and are made out of metal. They are genuine items that are supplied by the original equipment manufacturer for use with Craftsman air compressors. During replacement, it may require a wrench to help install these parts correctly. They will require replacing if they become bent or broken.
This chain saw bar is an authentic Craftsman replacement part and is compatible with chain saws. The chainsaw chain attaches to and rotates around the chainsaw bar. This part is made of steel and is sold individually. For installation, you will need a sprocket wrench and flat head screwdriver to retention the chain.