Designed for use in various chainsaws, the E-Ring secures the pivot pin, which holds the handguard. It is an authentic OEM replacement part made of durable black metal and sold individually, not as part of a kit or assembly.
When this part malfunctions, you may notice the handle or handguard is loose. At which point, it will need to be ...Read morereplaced. To complete this repair, you will need a pair of pliers.
Customers rate this repair as Easy.
This M8 flange nut secures the guide bar and chain assembly in place, ensuring proper alignment and safe operation of your equipment. Designed with an integrated flange and anti-slip teeth to resist loosening from vibration, it provides a reliable, secure hold during heavy use. Made from durable, corrosion-resistant steel with an M8 threa...Read mored and 1.25?mm pitch, replacing a worn or missing nut helps maintain stability and dependable performance.
This is a genuine OEM approved replacement screw made for Husqvarna chainsaws and brush cutters. It is a standard hardware which has multiple uses based on your equipment. Please refer to diagrams for correct application. It is made out of metal and it is sold individually. You would need a torx screwdriver to install or remove this screw.
It is an authentic OEM sourced item which is specifically produced for use with Husqvarna and Jonsered chainsaws. The spring fits onto the knee joint and is made of metal. During installation, a wrench set, a screwdriver, and a set of pliers may all be needed to help replace this part. It will need to be replaced if it becomes broken or stretched. Keep in mind that this part is sold individually.
This is an authentic Husqvarna replacement part that has been sourced from the original manufacturer to be used with chainsaws. The metal spring is part of the rear handle and is used to provide tension on the trigger to keep the trigger pressed outward. This item is available as an individual replacement part.
This is a genuine Husqvarna part that is OEM sourced to ensure a high level of quality. This item is intended to be used with chainsaws. The guide bushing is used to secure the cover to the chain brake housing assembly. This item is sold as an individual replacement part.
This knee joint is a genuine replacement part sourced directly from Husqvarna. It is compatible for use with many models of chainsaws. This knee joint It is made of metal and plastic. It should be replaced if it is broken. A screwdriver is needed for the replacement of this part. It does not include the pin (part 503892901).
It is a genuine part that is supplied by the original equipment manufacturer for Husqvarna chainsaws. The purpose of the vent tube is to allow air into the fuel tank so that a vacuum is not created when the fuel is being fed through the fuel line. It is an identical replacement for a missing or a faulty part that was installed on a new un...Read moreit. To ensure the proper replacement procedure, refer to the appropriate diagrams for your model. It is a high-quality fuel tank vent which is made of durable plastic and is sold individually. Replacing it is a simple task that should not require any special tools. Disconnect the old vent from the hose and connect the new one.
This is an original part from Husqvarna. The plate is constructed of metal, and is fitted onto the chainsaw crankcase assembly. This protective component is sold individually, and a screwdriver is required for the removal and replacement.
It is an authentic item that is supplied by the original manufacturer for Husqvarna chainsaws. This is the special pin that secures the throttle catch to the housing. It is an identical replacement for a damaged or a missing hardware that was installed on a new equipment. One durable metal pin is included. You may need a screwdriver to re...Read moremove the old pin and secure the new one. Check the diagrams of your model for the exact location and the correct application of this component.