Genuine OEM Replacement Part used on a variety of Power Equipment. This part is made out of Metal and is Sold Individually. Terminal Eyelet allows you to safely and easily secure a wire to the needed part of the tool using only a screw.
This is a genuine Porter Cable replacement part, it is sold individually. A Cord Strain Reliever is used on most all power tools. It purpose is to reduce the bending of the cord as it comes out of the housing, which otherwise would cause the cord to crack and wear.
This is a genuine Porter Cable replacement part, it is sold individually. The purpose of the A23158 Dust Bag is to pick up dust and debris when using the Belt Sanders listed below. It is connected to the spout at the top of the Belt Sander Housing.
This is a Genuine OEM Approved replacement part used on Porter Cable Sanders. This switch has a Plastic Body and it includes Metal Screws and Terminals. Switches are a commonly replaced part in power tools, handling on/off operations. Because switches use mechanical internals, they will degrade and wear out over time, eventually requiring...Read more replacement. To replace this switch you would need a Screwdriver. • First make sure the tools is not plugged in • Then you want to remove Screws used to hold two pieces of Housing Set together • Disconnect Wires from the old Switch and remove it from the Housing • Place the new Switch in the Housing and connect Wires to it • Reassemble the Housing
This item has been sourced from the original manufacturer and is intended to be used with belt sanders from Porter Cable. The metal drive pinion is used to link the motor gear and the large pulley to allow the two parts to rotate in unison. This item is sold as an individual replacement part.
This cord is a genuine Porter Cable replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. rnPower Cord Specifications: rn • 3 Prongs rn • 3 Wires rn • 16 Gauge rn • 7 Feet Long
This is a genuine drive pulley for a Porter Cable Belt Sander. The drive pulley transfers power between the sander's motor and the drive belt. Over time, the pulley can wear out needing replacement. It is recommended when replacing this part to inspect the drive belt (848530) for any wear and tear and replace if needed. The metal drive pulley is an individually sold part.
This is an authentic replacement part manufactured for use with Porter Cable variable speed belt sanders. The speed control regulates the power sent to the motor to adjust the motor output. This speed control assembly is sold as an individual replacement part, please see model diagram for associative parts.
It is a genuine OEM supplied replacement screw which is specially designed for use with power tools. This is one of the screws for the unit, please refer to the appropriate diagrams of your model for the correct location and use of this hardware. Please note it is made of high-quality metal and is sold individually.