This is a Genuine OEM sourced replacement part designed for use with Waring Blenders. This is the Blade that cuts food inside the container. It is made out of Metal and it is Sold Individually. To replace it you would need a Wrench or Pliers. • First you want to remove the Nut that secures the old blade assembly • Remove the cutte...Read morer assembly and make sure to clean the gaskets • Secure the new blade assembly using the Nut
This is a genuine manufacturer approved replacement part designed for use on Waring blenders. This item fills the center hole in the outer lid. It is made out of clear plastic and it is sold individually.
This is a genuine manufacturer sourced replacement part used on Waring blenders. It helps to distribute the pressure evenly and provides a tight seal for the bearing holder. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these se...Read moreals and washers will become brittle and compressed, then will have to be replaced. For proper application please refer to diagrams of your unit. This part is made out of rubber material and it is sold individually. To complete this repair you will need a wrench.
Genuine Waring replacement part, this item is sold individually. This part acts as a seal for the blenders shown below. It is installed along with other seals and washers underneath the cutter assembly, to prevent leaks from coming out of the bottom of the container. Over time these seals and washers will become brittle and compressed, then will have to be replaced.
This is a genuine manufacturer sourced replacement part used on Waring blenders. It helps to distribute the pressure evenly and provides a tight seal for the bearing holder. For proper application please refer to diagrams of your unit. This part is made out of metal and it is sold individually.
An authentic manufacturer-sourced replacement part which is specially designed for use with Waring blenders. This is one of the washers for the blade and the jar assembly, for correct location please make sure to check appropriate diagrams for correct location and use of this item. It is a high-quality component which is made of durable metal and it is sold individually.
This is a genuine part that is supplied by the original manufacturer for use with Waring blenders. The drive coupling spins on the motor shaft to rotate the blades. This part is made of plastic and is sold individually. To remove an old coupling, use a flathead screwdriver to pry it up and off. It doesn't need to be very tight, as you use the blender it will tighten on its own.
It is a genuine OEM supplied replacement hardware that is specially produced for Waring blenders. This is the hex nut that is secured on the bottom of the blender jar. Please note one durable metal item is included per order.