Genuine Delta replacement part, this item is sold individually.
The purpose of the is nut is to secure the blade of the Table Saw to the Saw Arbor.
It is a left hand ACME thread.
It is used on all of the right tilting Table Saws listed below.
Restore reliable performance to your Delta power tools with this genuine manufacturer-approved replacement switch. Designed for select Delta models, this part controls the on/off function and is a common replacement due to regular wear and tear. Over time, the internal components of switches can wear out, making replacement necessary to k...Read moreeep your tools running safely and efficiently.
This switch is sold individually and is built to meet the original equipment standards for quality and durability. Whether you're repairing a favorite tool or performing routine maintenance, this part helps ensure smooth operation and dependable control.
This Ball Bearing is sealed on both sides. This genuine Delta replacement part is sold individually. rnrn • Ball bearings minimize friction between rotating parts in your tool. The balls or rollers bear the load and spin, distributing the weight evenly, while the minimal contact area of the balls reduces friction. This reduces wear on ...Read morethe tool, allowing it to run smoothly. rn • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.
This is an authentic manufacturer-supplied part which is specially made for Delta equipment. It is one of the special screws utilized to secure the nameplate. Please refer to appropriate diagrams of your model for the exact location and use of this hardware. This high-quality drive screw is made of durable metal and is sold individually. ...Read moreNote, the screw is installed into a pre-drilled hole. You will need a hammer to secure this component.
This is an original Delta replacement part manufactured for use with drill presses and table saws. The special hex nut has multiple applications depending on the model drill press or table saw. This hex nut is sold as an individual replacement part, please see model diagram for part location and usage.
This special nut is priced individually and fits next to the lock washer. It is made out of metal and will need to be replaced if it becomes stripped or broken. A wrench will be needed during the installation of this part. The nut is an authentic part from Delta to be used in drill presses.