332K (Type 3) Porter Cable Orbital or Palm Sander - Overview

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This cord has a 220V plug.

It is a genuine manufacturer-approved switch which is specially made for Porter Cable and Black and Decker sanders. It is the part of the tool handling on/off operations. Unfortunately, over time components will wear out and it may begin to fail eventually requiring a replacement. Make sure to refer to the appropriate diagrams of your mod...Read moreel for the correct location and application of this switch. Keep in mind it has a durable plastic body and is sold individually. NOTE: This is a 220/230 Volt switch for the Porter-Cable models listed below. It will not work with 120V tools. The 120V switch is available here #875276 Switch (120V) .

This Ball Bearing has metal shielding on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This ...Read morereduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.

This replacement screw is a genuine OEM sourced item that is specially made for use with electric power tools. It is a standard hardware which has multiple applications depending on the unit, to ensure correct location and use of this screw check appropriate diagrams of your tool. Note, this hex socket head screw is sold individually.

Genuine Porter Cable replacement part, this item is sold individually. This screw is used in various parts of the tools shown below. It can found in each of the tools securing different internal parts of these tools. It is a Torx T-25 screw.

This part is supplied by the original equipment manufacturer for use with Porter Cable, DeWALT and Black and Decker power tools. The ring is generally utilized to secure a component on a shaft. It is a standard hardware which will have multiple applications, make sure to check the diagrams of your model for the exact location. Keep in min...Read mored this high-quality part is made of durable metal and is sold individually. It is recommended to use snap-ring pliers to secure or remove this hardware.

This cord protector is a genuine Porter Cable replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched. Which can expose the wires and become a safety hazard.

This is a Ball Bearing that is sealed on both sides. This is a genuine Porter Cable replacement part that is sold individually. • Ball bearings minimize friction between 2 parts in your tool that would otherwise spin and rub against each other. The balls or rollers take the load and spin, distributing the weight evenly while the mini...Read moremal contact area of the balls reduce friction. This reduces wear on the tool and allows it to run smoothly. • Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.