3328 (Type 1) Black and Decker Router - Overview

This cord protector is a genuine DeWalt replacement part and is sold individually. Cord Protectors are designed to slide onto your cord and fit securely at the end, where it's firm rubber will protect the base of the cord from getting bent and pinched, which can expose the wires and become a safety hazard.

This cord is a genuine DeWalt replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 3 Prongs • 3 Wires • 16 Gauge • 15 Feet Long

Included in part number 450503-01

Included in part number 144074-71

This is a genuine replacement part sourced from the original manufacturer for use with routers, grinders, and chop saws. The special brush cap is commonly used to provide a backing for the brush spring and to provide easy access to the brushes. This brush cap is available as an individual replacement part, please see model diagram for associative parts.

This part is an OEM genuine replacement plug for Craftsman tools. The housing of this plug is made of a high quality durable material. It comes complete with neutral, hot and ground prongs, in order to make a safe and complete circuit. The connecting screws do come with this part, however the tools needed for replacing this part may vary....Read more Please see our repair forum for instructional videos to aid in the replacement of this part.

O-rings are designed to contain thousands of pounds of pressure by creating a seal between two or more parts. O-ring measurements are defined by the inside diameter and the thickness. rnrnThere are many causes for O-Ring failure, such as pressure, friction, temperature or chemicals. The most common are: rn • Extrusion and Nibbling...Read moreu> - O-ring has ragged, tattered edges. These are commonly caused by pressure spikes which shear off tiny "bites" from the o-ring, or caused by clearance gaps. rn • Abrasion - One or both sides of the o-ring appear rough and slightly flattened. Commonly caused by a contact surface that is too rough, contains grit or is too smooth to allow lubrication. rn • Over Compression - O-ring is flattened on both sides and may have a "ring" split along its length. Commonly caused by excessive pressure or heat. rn • Heat Hardening - O-ring has a pitted or cracked surface, and often is flattened on both sides. Caused by temperature exceeding o-ring capacity.rn • Weather/Ozone Cracking - O-ring is covered in small surface cracks. Caused by exposure to ozone, UV rays and air pollution. Excessive seal stretching causes similar cracking.

Read less