3320-01 (A) Skil Table Saw - Overview

This is a genuine Skil replacement part that has been sourced from the original manufacturer. The crank is intended to be used with drill presses. This part attaches to the table assembly near the table bracket. This item is used to actuate the elevation gears to raise and lower the table. This item is sold as an individual replacement part.

This part is an OEM item. The spring set is intended to be used with drill presses from Skil. The spring set fits into the head of the drill, and is used to provide torsion to allow the handle to retract when raising and lowering the spindle. The spring set contains the housing, the spring, and retaining plate, and is priced as an individual part.

This is a genuine Skil replacement part used in compatible drill presses. The adjustment knob is made out of metal and plastic. No tools should be needed when replacing this item. It may become broken or stripped and will need to be replaced. This is available as an individual replacement part.

This is an OEM sourced replacement part designed for use with Skill drill press. It allows user to secure drill bits. The ratcheting action clicks the jaws tightly into place for reduced bit slippage. If bit retention is suffering, the rotation feels stiff or the chuck has seized up entirely, a new chuck should fix the problem. This kit i...Read morencludes a metal chuck and a chuck key. Drill press chucks fit into presses with a Morse taper. The steps for drill press chuck removal/installation are different than for other chuck types. • Using a chuck removal tool is the easiest way to remove a drill press chuck. • The chuck removal tool fits inside a window on the press spindle. • Lightly hammering the tool into the window causes the chuck to fall out. • Clean the spindle of the chuck with a rag and a degreasing agent. • Once the shaft and spindle are clean, insert the drill chuck into the press firmly enough for it to stay in on its own for a moment. • Retract the jaws of the drill press chuck to prevent damaging them. • Lower the press table to open up some hammer-swinging space. • Using a wooden or rubber mallet, strike the bottom of the chuck quickly and forcefully two or three times. Don't be fooled by the simplicity of the Morse taper design. If done properly, this easy installation will ensure that that chuck stays firmly engaged in the spindle until it's meant to come out.

This is an authentic Skil chuck wrench also known as a chuck key is designed for use with a drill press. It allows user to tighten and loosen the jaws of the chuck to secure and change drill bits. Please note, one metal wrench is included per order.