This O-ring is a genuine OEM replacement part designed for use in a variety of power tools. It is a rubber seal used to prevent pressure loss, as well as oil, fuel, and air leakage from the fuel hose. It can be found on either end of the hose. You will need to replace this ring if it has lost elasticity, or if it is cracked or deformed. T...Read morehe O-ring can fail due to age, exposure to heat and chemicals, pressure buildup, or poor installation. A faulty ring will result in leakages, pressure loss, and decreased equipment performance. Carefully pry the old O-ring off the hose. Remove any dirt or debris in the area and lubricate the new ring before placing it in position. Apply light pressure to the ring until it is secure and sitting snugly. Note that your equipment may have several O-rings, therefore, inspect all of them as each ring is sold individually.
This is a genuine part which is supplied directly by the original equipment manufacturer and is used with Husqvarna and Jonsered hedge trimmers. The fuel filter removes debris before it reaches the carburetor in your gas-powered equipment. This part made of metal and is sold individually. For installation, you will need a socket wrench to remove any shrouds or panels, and a pair of needle nose pliers to aid you.
This stop button is a safety feature used in various types of lawn and garden equipment. It is a genuine OEM replacement part which is responsible for quickly shutting off the engine in case of an emergency or when it is no longer in use. The stop button is fitted into the handle controls for easy access. If the stop button becomes damage...Read mored or dislodged from its position, you will not be able to stop the equipment in an emergency. Therefore, it is important to replace the faulty stop button promptly to ensure that this emergency measure remains available, and avoid injury to the operator. Before beginning the repair, ensure that the equipment is turned off. Disconnect the stop button wires and detach the old stop button from the handle controls. Plug the new stop button in in place and reconnect the wires. If your equipment has fasteners with hex sockets, you will need to use a hex key/Allen wrench to remove and install the stop button. Ensure that the button is fitted securely before attempting to use your equipment again.