321201 Weber Grill - Overview

This is an authentic Weber replacement part that has been sourced from the original manufacturer to be used with natural gas grills. The brass coupler is used to connect the fuel hose to the natural gas supply. This quick disconnect is sold as an individual replacement part, tools may not be needed to install this item.

This Weber logo is an original replacement part supplied directly from the manufacturer. It is compatible with 150+ models of Weber grills. This logo is placed on the lid of the grill. Replacing this logo will keep your machinery looking pristine. Two fasteners are included with this part.

This is a Genuine Manufacturer Sourced replacement part used on a variety of Weber Grills. This is a Metal (Aluminum) assembly used to prevent drippings and food particles from marring your deck or patio.

This is an authentic OEM sourced replacement part designed for use with Weber grills. These rails are used to hold the grease/drip funnel tray to the underside of the grill so you can slide the tray in and out for easy cleaning. This set includes two (2) aluminum bottom tray rails with four (4) screws used to mount rails. To complete this repair you will need a screwdriver.

This is an authentic kit made for the lid on Weber grills. This is a 14-part set that includes two posts, two retaining clips, and ten hex nuts. The posts are used to secure the lid to the body of the grill while allowing it to swing freely as a hinge. The ends of the posts have small holes that the retaining clips slide into to keep them in place.

This is an original Weber part manufactured for use with outdoor grills. The control panel plugs with screws fasten the control panel to the side frame. Only two plugs are required to secure the control panel, and this set will include both plugs, and two screws, please note the set is sold individually.

This replacement burner tube set is supplied directly from original equipment manufacturer. It is commonly use on Weber grills. Burners are a key component of a gas grill because, it is where the flames would rise from. They are connected to control valves. This set includes three (3) stainless steel burner tubes, one (1) carry over tube ...Read moreand the hardware to secure the burners. Replacing burners is a simple task that should only require a wrench. • Make sure gas tank is disconnected • Remove screws securing the old burners • Disconnect old burners from control valves and replace them with a new burners • Secure burners using the included hardware and • Secure the carryover tube • Connect the gas tank and test the burners

This is a Genuine Weber replacement part designed for their Grills. Kit includes: push-button igniter, gas-catcher ignition chamber, white wire, black wire, and instruction sheet. Hassle-free installation enabled by easy-to-follow instructional guide