Length: 8'
Gauge: 18
Wires: 2
Type: Bare Wire
This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the...Read more new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.
This is a genuine OEM replacement part, it is sold individually. This part is used to keep the brush tight against the armature so the tool will work properly. Over time when the brushes wear down and heat is created, the spring may lose its tension and will have to be replaced.
It is a genuine OEM sourced replacement hardware that is specially designed for use with Black and Decker and Dewalt shears. This is one of the screws used to secure the knife blades, please note the inserts to lock them are sold separately. Please note this durable high quality special screw is sold individually. You will need a hex key also known as an allen wrench to secure or remove it.
This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.
Genuine OEM replacement part, this item is sold individually. This screw is used in various places in all of the tools listed below The most common use for this screw is to secure plastic housings together. It has a Torx T-20 head.
This is a genuine replacement part that has been sourced from the original manufacturer to be used with shears from DeWalt, Porter Cable, and Black & Decker. The metal knife attaches to the front housing and is used to cut through material on the right side of the center knife. This item is sold as an individual replacement part.
The spacer goes between the blade and the knife and is made of metal. This part is an OEM from DeWALT, Porter Cable, and Black & Decker for use in shears. This item is available as an individual replacement part. You may need a set of pliers when replacing this item. Over time this part may break and will need to be replaced.
This is an authentic DeWALT replacement part. The spacer is found in power shears, and is generally used to maintain separation between the left knife and the center knife. Please be aware that there are different spacers used in the machine. Refer to the parts diagram to be sure of ordering the correct part. This part is made of meta...Read morel, and is sold individually. You may require a screwdriver to replace this item.
This knife is an authentic replacement part sourced straight from the original equipment manufacturer. It is most frequently used in gauge shears. This part is made out of metal, and it is sold individually. Please note the right knife is sold separately as part 91967-00.
This is an original replacement part manufactured for use with electric power tools. The special sleeve is commonly used to provide spacing between the armature bearing and the motor housing. This sleeve is available as an individual replacement part, please see model diagram for associative parts.