This is a replacement screw, also known as a shear pin that is used in several pieces of outdoor power equipment. It is made of metal and is approximately 2 inches in length. It is a hex head screw and is sold individually. This is an OEM part sourced directly from the manufacturer.
This Ni Nut-Lock, or Nylock Nut, is a Silver 1/4 x 20 metal nut. Sold individually, it can be adjusted using a wrench or socket and torque wrench to the manufacturer specfications, and is used to secure the sheer pin in place, on the impeller assembly. These nuts are a one-time use part due to their locking mechanism. You'll know the nut...Read more has broken when it appears to have damaged threads or rounded off edges.
Customers found this to be an easy repair.
This is an original replacement part sourced directly from the manufacturer. The screw is commonly found in yard equipment from Craftsman, such as lawn tractors, snow blowers, and edgers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different screws...Read more used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You will require a wrench when replacing this item. The screw is sold as an individual replacement part.
The fuel tank goes between the fuel tank bracket and the fuel line. This is a Tecumseh, Husqvarna, and Toro replacement part directly sourced from the manufacturer for use in engines and snowthrowers. This part holds the fuel and is priced individually. A wrench might be required during the replacement of this part. It will need to be replaced if it leaks.
This OEM Carburetor Bowl Gasket attaches between the carburetor bowl and carburetor in order to seal the parts together. This model is rubber, black, and comes individually sold. Installation is rated as "Easy" by customers, and will require pliers and a socket set. If the part becomes broken due to wear/damage then there may be a fuel le...Read moreak, and the part will need to be replaced. Refer to your make, model and diagrams to ensure you've chosen the correct part.
Feed oil to the guide bar and chain with this oil cap and squeeze-bulb assembly for electric chain saws and pole saws. The cap closes the oil tank, while the built-in bulb operates the manual oiling system. Pressing the bulb sends oil to the bar and chain before a cut. Replacement may be needed if the bulb is torn, the cap is cracked, or ...Read moreoil leaks around the opening. Unplug the tool, allow the chain to stop, and wear protective gloves before installation. Wipe away spilled oil and tighten the cap firmly.
The Fuel Line Clamp is a metal, individually sold part which clamps onto the fuel line, securing it to a port and preventing leaks. Installation is rated as "Easy" by customers and will require pliers and a screwdriver. If broken due to wear/fatigue/damage, there may be a fuel leak and the part should be replaced. Refer to your make, model and diagrams to ensure this is the correct part.
This 1/4-20 x 3/4-inch hex-head screw secures parts on compatible outdoor power equipment. It is made from Grade 5 steel and has a yellow zinc finish for added rust resistance. Check the equipment model and parts diagram before ordering.
This is a genuine replacement part that has been sourced from the original manufacturer to be used with snow thrower engines from Husqvarna and Toro. The metal screw is used to fasten the fuel tank to the tank mounting bracket. This item is available as an individual replacement part, please note a hex socket wrench may be needed to install this item.