3100120V (F 013 310 000) Dremel Hammer Drill - Overview

This is a genuine OEM replacement part, it is sold as a set (2)Two Brushes and two Brush Springs. Worn brushes frequently are the cause behind a motor running poorly. • Replacing brushes can fix a motor that's operating intermittently. • New brushes can restore a motor's electric braking. Carbon brushes are one of the most com...Read moremonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

Genuine manufacturer sourced replacement switch used on Dremel rotary tool. It is an important part of the tool which handles on/off operations. Because switches have mechanical parts, they will tend to wear out over time, eventually requiring replacement. Switch has a plastic body and it is sold individually. To replace this switch you ...Read morewould need a Screwdriver. • Remove screws used to hold two pieces of housing set together • Disconnect wires from the old switch and remove it from the housing • Place the new switch in the housing and connect wires to it • Reassemble the housing

This is a genuine Dremel replacement part, it is sold individually. The purpose of the Collet Nut is to secure the collet with the bit of your choice in the shafts assembly of the Dremel tools shown below. By pressing on the lock assembly on the tool and using the wrench provided with your tool you can secure or release the Collet Nut.

This is a Genuine Manufacturer Approved replacement part used on some Dremel Rotary Multi-Tools. This part provides the firm grip for holding a bit in a tool. This Collet is for using bits with 1/8" arbors. Due to prolonged, heavy use a collet may need to be replaced. Collet Nut is sold separately.

This is a genuine manufacturer-supplied part that is made for Dremel power tools. It is utilized to provide a tight fit between connected components while helping to reduce vibrations. Over time the material will wear out and it may begin to fail eventually requiring a replacement. This high-quality damping rubber is made of durable mater...Read moreial and is sold individually. Refer to the parts diagrams for your model to ensure the correct repair procedure.