306A Poulan Chainsaw - Overview

Compatible with over 150 models of lawn equipment, this Spark Plug has been sourced directly from the original manufacturer. It is sold individually, made of metal and ceramic components, and is not part of a kit or assembly. The spark plug is used to ignite the air-fuel mixture inside the combustion chamber. You may need to replace the...Read more Spark Plug if your 1 cylinder engine won't start, or if your more-than-1 cylinder engine runs rough. Spark Plugs will wear over time and should be inspected regularly. Customers rate this repair as Easy.

The chainsaw starter rope is a three-foot-long white rope that is approved by the original equipment manufacturer, and which wraps around the recoil pulley and is pulled to start the engine. Installation is rated as "Easy" by customers and requires a screw driver, pliers, and torx screwdriver. If the rope breaks it should be replaced. Ref...Read moreer to your make, model and diagram to ensure this rope is right for your machine.

This bar adjusting pin hooks onto the crankcase along with the bar adjust retainer and the screw. When you tighten the screw it helps to place tension on the bar. This high-quality pin is made out of metal and is sold individually. It is an authentic OEM sourced item which is specially produced for use with Poulan chainsaws. A screwdriver and a socket set may be needed when replacing this part.

Starter-handle

This part is an OEM from Poulan for use with Chainsaws. The chain guide plate holds the bar to the clutch. The most common reason for replacing the chain guide plate is if the Plastic housing is wearing (or melting) beneath the guide bar, the bar plate is worn or damaged from the chain, bar oil is not circulating or the oil is not reachin...Read moreg the chain. Here is a list of tools that are needed to install the chain guide plate a chain adjustment tool (scrench); or ratchet/socket/wrench set, flat-blade screwdriver, long-handled screwdriver, and a small hammer.

This is an authentic replacement part manufactured for use with Husqvarna chainsaws. The multi-tool is used to service the chainsaw. The tool\'s hex socket can be used to remove parts such as the chain brake cover nuts or spark plug. The multi-tool has a flat screwdriver that can be used to adjust the tension of the bar. This multi-tool is sold as an individual replacement part.