30646 Toro - Overview

This oil seal is an OEM replacement part designed to prevent oil from leaking from the engine or gearbox while keeping contaminants from entering. It is used in various lawn mowers where it ensures that the moving parts in the mower remain adequately lubricated and protected from dirt/debris. The oil seal can wear down due to aging, heat,...Read more pressure, or improper installation. If the seal is no longer functioning oil will leak, the engine will overheat, and its internal components will wear down due to excessive friction. Use seal pullers to remove the seal from its housing on the engine crankshaft or transmission housing. Clean the surrounding area using a cloth or soft brush to prevent contamination and ensure a good seal. Apply oil to the lip of the new seal and firmly press into position until it is flush against the sealing surface. Once you have completed the repair, run the lawn mower to check that there are no longer any leakage or performance issues.

It is a genuine OEM item that is made for Toro lawn and garden equipment. This is a special component which helps to provide a tight fit between connected parts. Unfortunately, over time it may wear out, get damaged or lost eventually requiring a replacement. This high-quality bushing is made of durable material and is sold as an individu...Read moreal item. To ensure the proper repair procedure, check the parts diagrams for your specific model.

This is a genuine OEM sourced hardware that is specifically made for use with Toro lawn and garden equipment. It is a standard hardware which may have multiple applications depending on the model of your unit. Please make sure to refer to the appropriate diagrams for the correct location and application of this part. Keep in mind this hig...Read moreh-quality flange nut is made of durable metal and is sold individually. Note, you will need a wrench to secure or remove it.

This flat metal washer fits onto the speed guide-selector and is available individually. Please note that more than one washer may be needed when replacing parts. It will need to be replaced if it becomes lost or broken and may require a wrench during installation. This is an OEM Toro part sourced directly from the manufacturer and used in snowthrowers.

This lock nut is used to secure threaded fasteners, to prevent them from loosening and falling off during use. It is sourced from the original manufacturer for use in various lawn and outdoor equipment. The nut has a nylon insert on one end which holds the fastener and locks the nut in position. It comes in a hexagonal shape, which makes ...Read moreit easier to grip, and ensures better stability. It is normal for a lock nut to corrode, crack or wear down over time. You will likely notice increased vibration, noise, and instability from your equipment when the nut is no longer able to securely hold the fastener. To remove and replace a lock nut, nut use a wrench or socket. Regularly inspecting and replacing the lock nuts in your equipment is important in maintaining the longevity of the equipment. Each nut is sold individually.

This is an authentic HHHH replacement part, sourced from the original manufacturer for use with outdoor power equipment. The special lock nut is used with several different types of equipment and the application of the nut can vary based on the model of the tool. This lock nut is available as an individual replacement part.

This individual rubber O-ring is a genuine OEM part for various outdoor equipment models and has an approximately 1-inch inner-diameter. O-rings are typically used to seal various gaps within hydraulic systems to prevent the escape of liquids or gases, and if you notice that the motor of your equipment is leaking or performing poorly, it ...Read moremay be a sign of an aging O-ring, because over time they lose their elasticity and crack. Be sure to check any diagram of your equipment for the exact placement of this O-ring.