3002 - Overview

This is an original replacement part sourced directly from the manufacturer. The screw is commonly found in yard equipment from Craftsman, such as lawn tractors, snow blowers, and edgers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different screws...Read more used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You will require a wrench when replacing this item. The screw is sold as an individual replacement part.

This silver metal lock washer helps prevent the nut on the drive belt pulley shaft from backing off during operation, it has a 5/16-inch inner diameter and a 1/2-inch outer diameter. one washer is included, replace it if fatigue or damage allows the connected shafts to spin freely, verify fit using the equipment model or owner manual

This is a genuine OEM sourced replacement flange nut that is specially produced for Little Wonder electric hedge trimmers. This nut will resists loosening when properly threaded onto a bolt. It is generally used to secure the blades and the bar together. Please note, it is sold individually. You will need a wrench to tighten or loosen this flange nut.

This is a genuine Little Wonder replacement part that has been sourced from the original manufacturer to be used with hedge trimmers. The metal screw is used to secure the blades, guard, and bar. This screw is available as a single item, please note the nut is separate.

This is a genuine manufacturer-sourced replacement gasket which is specially designed for use with Little Wonder hedge trimmers. The part provides an air-tight seal between connected parts, please refer to the appropriate diagrams of your model for the correct location and application of this hardware. Over time the gasket may wear out an...Read mored begin to crack eventually requiring a replacement, keep in mind this high-quality composite material item is sold individually.

This is an original replacement part sourced directly from the manufacturer. The V-belt is commonly found in MTD tillers. This part is made of flexible rubber, with a tight fabric casing. It is used to transfer motion from the engine to the tiller blades. You may require a wrench when replacing this part. Since this is a common wear item, you may wish to order a spare. This part is sold individually.

This is a genuine Little Wonder replacement part that has been sourced from the original manufacturer to be used with hedge trimmers. The guard is used with one-sided blades and is used to cover the back side of the blade near the motor. This part is priced as a single item.

This is a genuine item that is supplied by the original equipment manufacturer for use with MTD and Ryobi lawn and garden equipment. It is a standard hardware which has multiple applications, please make sure to refer to the diagrams of your model for the correct location and application of this item. Keep in mind it is made of durable metal and is sold individually.

This Bell-Wash Flat Washer is an OEM part that measures .40 inches I.D. x 88 inches O.D. This washer is a silver, metal, washer sold individually. This part is rated as Easy to install by customers. If missing or damaged (likely due to fatigue) it should be replaced. Refer to your owners manual to ensure this is the correct part for you.

An authentic item which is supplied directly from the original equipment manufacturer for use with Toro and Lawn Boy lawn and garden equipment. It is a high-quality replacement for a worn or missing component which helps to short block, please make sure to refer to the appropriate diagrams of your model for the correct location and applic...Read moreation of this hardware. Over time the material may wear out and begin to crack eventually requiring a replacement, keep in mind this durable part is made of rubber material and is sold individually.