A genuine Delta replacement part, sold individually. A trunnion is a cylindrical protrusion used as a mounting and/or pivoting point. Held in place by three Cap Screws (901027631530), this part is compatible with the band saws listed below. A wrench is needed for repair.
This is an authentic Delta replacement part that has been sourced from the original manufacturer to be used with band saws. The metal door catch attaches to the wheel guard and is used to secure the door lock stud. This item is available as an individual replacement part, please note two are required.
It is an authentic item that is supplied directly from original equipment manufacturer for use with Delta power equipment. This replacement bearing helps to secure the spindle while allowing it to rotate with minimal friction. For correct location and use of this item make sure to check appropriate diagrams of your equipment. Please note this durable metal bearing is sold individually.
This is an Genuine Manufacturer Authorized replacement part used on Delta Band Saws. Ball bearings are used to reduce friction between rotating parts. The balls or rollers take the load and spin, distributing the weight evenly while the minimal contact area of the ball reduces friction. This reduces wear on the tool and allows it to run s...Read moremoothly. Bearings experience constant wear when the tool is in operation from pressure, heat, vibration and friction. Because of this, many Bearings need periodic maintenance or replacement.
This is a genuine OEM sourced replacement part designed for use with Delta band saws. It helps to protect the user and the blade while allowing blades to run cooler and last longer with less friction allowing for a higher re-saw capacity. This guide block is made out of metal and it is sold individually.
This is available as an individual replacement part. The keps nut attaches to the bracket and is made of metal. During replacement, it may require a wrench set to help install this item correctly. It will require replacing if it becomes broken. This is a genuine Delta replacement part used in compatible table saws, unisaws, and band saws.
This is an authentic Delta replacement part that has been sourced from the original manufacturer to be used with band saws. The metal bracket attaches to the blade guide and is used to support the guide blocks. The bracket is secured using thumb screws so tools may not be needed to install this item. The bracket is an individual item.
The blade guard attaches to the bracket and is made out of metal. This part is an OEM from Delta for use band saws and is available as an individual replacement part. It may require an allen wrench during installation and will need to be replaced if it becomes cracked or broken.
This matched set includes two V-belts that move power from the motor to the band saw wheels. Both belts are 1/2 inch wide. One is 41 inches long, and the other is 59 inches long. The different sizes are needed for the saws drive system. Use the complete saw model, type, and serial number to guarantee the proper fit. New belts may look sma...Read moreller than the old belts because used belts stretch over time. Unplug the saw and follow the belt-routing diagram before installation.