2762-20 (F41A) Milwaukee Impact Driver - Overview

This is a genuine manufacturer-sourced part which has been designed for use with many impact wrenches. The Milwaukee detent pin is powered by the anvil's detent spring, which secures the driver socket of the wrench. A screwdriver and a pair of pliers may be helpful for the repair. The detent pin is sold individually.

This is a genuine OEM part. The (50 x 40mm pan head pt t-20) screw is made for use with several Milwaukee impact wrenches. The metal screw helps to fasten the front housing assembly to the clamshell housing, and is sold individually. You will need a screwdriver for the proper installation.

This is an original part from the Milwaukee manufacturer. The gasket is composed of cardboard composite, and is sold individually. Compatible with several impact wrenches, the gasket is fitted onto the rear case, providing protection from friction. You will need a screwdriver and pliers for the removal and replacement.

This is an authentic Milwaukee replacement part, sourced from the original manufacturer for use with impact wrenches. The pan head screw is commonly used to secure the two halves of the housing assembly. This screw is available as an individual replacement part, please see model diagram for associative parts.

This is a pivot pin designed for use in impact wrenches and drivers. Its purpose is to connect the hammer and the anvil, allowing the hammer to move back and forth and drive the bit into the material being worked on. The pivot pin measures approximately 0.5 inches in length and is sold individually as a genuine OEM part made of high-quali...Read morety metal. Because this is a high-wear component, the pivot pin can break or malfunction over time, necessitating replacement. If you notice that the assembly feels loose or wobbly, it is advisable to inspect the condition of this pin. If it is damaged or compromised in any way, it should be replaced. To replace this pin, you will need a punch and hammer to release the old pin, as well as a set of pliers to hold the detent pin in place when installing the new pivot pin.