2750-20 (G41A) Milwaukee Impact Driver - Overview

This spring is an OEM part direct from the Milwaukee manufacturer. Compatible with many drills, the metal spring is fitted inside the sleeve for resistance. This item is sold individually. A screwdriver and a pair of pliers may be helpful for the installation.

This external retaining ring, also known as a snap ring or circlip, is supplied by the original manufacturer for use in impact drivers. It helps to secure the collar in the front housing assembly. It should be replaced if it is lost, damaged, or no longer able to remain securely attached. To replace the retaining ring, disassemble the fro...Read morent housing assembly and pull out the ring. Position the new ring in its place and reassemble the housing. Each retaining ring is sold individually.

This is an authentic part which is sourced directly from the original equipment manufacturer for use with Milwaukee power tools. The 4mm ball is secured in the opening of a part allowing it to be secured. Over time it may wear out, get damaged or lost eventually requiring a replacement. Note, this high-quality 4mm ball is made of durable ...Read moremetal and is sold individually. Check the diagrams for your model to ensure the exact location and the correct application of this component.

This is a genuine Milwaukee part. It is sold individually. It attaches to the bottom of the housing on a Milwaukee cordless drill. Its purpose is to hold the small screwdriver bits that are inserted into magnetic bit holders. It is compatible with the Milwaukee tools shown below.

This genuine manufacturer-sourced component is made for use with Milwaukee power tools. It is an identical replacement for a missing or a faulty 5mm ball that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality part is made of durable metal and is sold individually.