2708 - Overview

This is a genuine Milwaukee replacement part, it is sold individually. The purpose of the 06-75-3150 Screw is to secure the chuck to the spindle of the models listed below. This is a left hand threaded screw, to remove it turn it clockwise. We do have an article and video on

This is a genuine Milwaukee Taptite-« Pan Head Torx Screw for use with a variety of equipment. Use only appropriate tools of correct size to tighten and loosen the screw while following the basic common safety precautions. Size 10-24 X 1/2.

Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together.

This is a genuine Makita replacement part that includes two carbon brushes with wire leads attached. Carbon brushes are essential components in power tools and are among the most commonly replaced parts due to regular wear from friction. Over time, worn brushes can cause a motor to run poorly, operate intermittently, or lose electric brak...Read moreing power. Replacing them can often restore your tool’s performance. A worn brush may appear cracked, pitted, burned, or worn down near the wire lead. It’s always best to replace both brushes at the same time, even if only one shows signs of wear. When installing new brushes, be sure to inspect the armature for any damage such as burns or cracks, which could indicate more serious motor issues.

Genuine Makita replacement part, this item is sold individually. The purpose of the Brush Holder Cap is to retain the brush in the brush holder. This Brush Cap is used on all the Makita models listed below. It is removed by using a slotted screwdriver Do not press too hard when removing the cap they do have a tendency to break.

This cord is a genuine Makita replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 3 Prongs • 3 Wires • 16 Gauge • 8 Feet Long

This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutters. The washer has multiple applications based on the model of the power tool. It is recommended to review your model's diagram to verify this washer's compatibility. The washer is sold individually.

This cord guard / strain reliever is a genuine Makita replacement part. It covers the final portion of cord before entering the tool, providing extra rigidness and preventing cord damage. Over time these cord guards break down and require replacement. The guard is constructed of heavy duty rubber compound for toughness. This cord guar...Read mored is compatible with the tools listed below. It is not guaranteed to fit any other power tool models.

This replacement part is an authentic manufacturer sourced screw that is specially designed for use with Milwaukee power tools. It is a standard hardware which will have multiple applications based on your tool. This taptite Torx screw is made of high-quality metal and it is sold individually.

A bit that slips, wobbles, or falls from the tool may point to a worn 7/16-inch hex chuck assembly. The chuck holds large hex-shank bits and transfers power from the drive system to the accessory. Before replacing it, inspect the bit shank, locking parts, spindle, and chuck opening for dirt or damage. Confirm fit with the complete tool mo...Read moredel and chuck size. Unplug the tool or remove its battery before service. Follow the repair guide for removal, install all small parts in the correct order, and make sure the bit locks firmly before use.

Genuine Makita replacement part. This pan-head phillips screw includes a washer. It is sold individually.