2705 - Overview

This is a genuine OEM part. The Ingersoll Rand reverse valve knob screw is compatible with the 231C 1/2" Drive Air Impact Wrench. The metal screw fastens the reverse valve knob onto the housing, and is sold individually. You will need a hex key for the repair.

Genuine Manufacturer Sourced replacement part used on a variety of Makita Power Tools. This is a Metal Pan-Head Screw and it is sold individually. This screws is commonly used to hold two pieces of Housing Set together.

This authentic replacement part which is specially designed for use with Makita power tools. Ball bearings are used to reduce friction between rotating parts, over time components may begin to wear out and fail eventually requiring a replacement. Please note this high-quality ball bearing is made of durable metal and it is sold individually.

This is a genuine Makita replacement part that includes two carbon brushes with wire leads attached. Carbon brushes are essential components in power tools and are among the most commonly replaced parts due to regular wear from friction. Over time, worn brushes can cause a motor to run poorly, operate intermittently, or lose electric brak...Read moreing power. Replacing them can often restore your tool’s performance. A worn brush may appear cracked, pitted, burned, or worn down near the wire lead. It’s always best to replace both brushes at the same time, even if only one shows signs of wear. When installing new brushes, be sure to inspect the armature for any damage such as burns or cracks, which could indicate more serious motor issues.

This genuine Makita replacement part is designed for use with a variety of power tools. This screw is a standard hardware which has multiple applications based on your tool. It is made out of metal and it is sold individually. Would require a screwdriver to install or remove this screw.

This cord is a genuine Makita replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Over time, power tool cords will wear out or become frayed. We recommend replacing a cord as soon as signs of wear are visible. Power Cord Specifications: • 2 Prongs • 2 Wires • 14 Gauge • 8 Feet Long

Genuine Makita replacement part, this item is sold individually. The purpose of the Brush Holder Cap is to retain the brush in the brush holder. This Brush Cap is used on all the Makita models listed below. It is removed by using a slotted screwdriver Do not press too hard when removing the cap they do have a tendency to break.

Genuine Makita replacement part, this part is sold individually. This screw is used to secure various internal and external parts in the tool models shown below.It is a metric screw sized M4 X 16 (W, SW).

This is a genuine OEM sourced replacement part which is specially made for use with Makita saws. It is a standard hardware which has multiple applications, please make sure to check the appropriate diagrams of your model for the correct location and application of this item. Keep in mind this high-quality tapping screw is made of durable metal and is sold individually.

This is a standard hardware which has different uses based on different tools it is compatible with. It is designed for Makita power tools. Please refer to the appropriate diagram for correct application of this bolt. It is a hex socket head bolt which is sold individually. When doing this repair you would need an allen wrench/hex key to remove or install this bolt.