2650-21 (B55B) Milwaukee Impact Driver - Overview

This is a genuine Milwaukee replacement part, it is sold individually. The Milwaukee 14-46-2012 Brush Card Assembly uses four brushes, whereas most power tools use two brushes. To replace this part you will need to release the spring tension on the brush then place the brush card in its proper position. Worn brushes frequently are the...Read more cause behind a motor running poorly. • Replacing brushes can fix a motor that's operating intermittently. • New brushes can restore a motor's electric braking. Carbon brushes are one of the most commonly replaced power tool parts. This is because carbon brushes are wear items, meaning that through friction and use they will gradually wear away until they need replacing. Worn brushes are a common causes of intermittent motor function, reduced electric braking and reduced motor power. A worn-out brush will often be worn down near to the wire lead and can be cracked, pitted, or burned. When replacing carbon brushes, be sure to inspect your armature for burns, cracks, or other damage which can indicate larger motor problems.

This spring is an OEM part direct from the Milwaukee manufacturer. Compatible with many drills, the metal spring is fitted inside the sleeve for resistance. This item is sold individually. A screwdriver and a pair of pliers may be helpful for the installation.

This is an authentic Milwaukee replacement part that has been sourced from the original manufacturer to be used with impact drivers, wrenches, and screwdrivers. The steel ball is used to reduce friction between the anvil and the impact assembly. The steel ball is priced as a single item.

This external retaining ring, also known as a snap ring or circlip, is supplied by the original manufacturer for use in impact drivers. It helps to secure the collar in the front housing assembly. It should be replaced if it is lost, damaged, or no longer able to remain securely attached. To replace the retaining ring, disassemble the fro...Read morent housing assembly and pull out the ring. Position the new ring in its place and reassemble the housing. Each retaining ring is sold individually.

This replacement sleeve is an authentic OEM sourced item that is specially designed for use with Milwaukee impact wrenches. It is an important part of hex drive chuck that allows for quick bit exchange. It is made from durable metal material and it is sold individually.

This is a genuine Milwaukee replacement part used in compatible hex impact drivers. The front case assembly fits next to the sleeve and the spring and includes four screws. A screwdriver might be necessary during the installation of this part. It will need to be replaced if it breaks. Keep in mind that this high-quality part is sold individually.

This genuine manufacturer-sourced component is made for use with Milwaukee power tools. It is an identical replacement for a missing or a faulty 5mm ball that was installed on a new unit. Please make sure to refer to the appropriate diagrams of your model for the correct location and application of this hardware. Keep in mind this high-quality part is made of durable metal and is sold individually.

This is an authentic replacement part manufactured for use with Milwaukee impact wrenches. The anvil assembly is used to deliver the impact when the spindle rotates. This metal anvil assembly includes the steel ball and is sold individually.

This end cap is an authentic OEM replacement part supplied directly from the manufacturer. It is crafted for use with Milwaukee impact drivers. This end cap provides protection for the service armature assembly. It is designed with several air vents to allow air flow and prevent overheating. It is made of plastic and should be replaced if...Read more it is cracked or damaged. Please note this part is sold individually and requires a screwdriver to install.