Models > 25311531101

25311531101 Kenmore Freezer - Overview

Sections of the 25311531101

[Viewing 3 of 3]
Keep searches simple, eg. "belt" or "pump".
Single Gasket Retainer Clip – Part Number: 5303212828
Single Gasket Retainer Clip
★★★★★
★★★★★
(2)
PartSelect #: PS457511
Manufacturer #: 5303212828
This genuine OEM freezer gasket retainer clip is used on refrigerator freezers, and connects the inner door panel and door gasket to the outer door panel. The gasket is the rubbery strip that seals th...
$16.24
  In Stock
Upper Freezer Basket - White – Part Number: 216916200
Upper Freezer Basket - White
★★★★★
★★★★★
(2)
PartSelect #: PS817256
Manufacturer #: 216916200
This freezer basket is designed to allow you to organize food easily in your chest style freezer. The durable basket measures approximately 13 inches wide x 9 inches high x 25 inches deep, and has a w...   No Longer Available
Touch Up Paint - White – Part Number: 5303321319
Touch Up Paint - White
PartSelect #: PS467298
Manufacturer #: 5303321319
This is white touch up paint for refrigerators, microwaves, ranges, dryers, and freezers. It is used to cover, or touch up, nicks and scratches on the appliance from wear and tear. It is an 18ml bottl...
$17.55
  In Stock
Run Capacitor – Part Number: 218909912
Run Capacitor
★★★★★
★★★★★
(3)
PartSelect #: PS817298
Manufacturer #: 218909912
This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.
$58.75
  In Stock
Compressor Relay and Overload – Part Number: 5304491584
Compressor Relay and Overload
★★★★★
★★★★★
(2)
PartSelect #: PS8689570
Manufacturer #: 5304491584
This part is both the start relay and the overload. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed and the overload provides extra protection against e...
$48.49
  In Stock
Hinge Kit – Part Number: 297321900
Hinge Kit
PartSelect #: PS2581693
Manufacturer #: 297321900
$72.82
  In Stock
GASKET-DOOR – Part Number: 216481211
GASKET-DOOR
PartSelect #: PS2378625
Manufacturer #: 216481211
$163.72
  In Stock
Interior Drain Plug – Part Number: 216502600
Interior Drain Plug
PartSelect #: PS426014
Manufacturer #: 216502600
$13.76
  In Stock
Filter - Drier – Part Number: 5303305677
Filter - Drier
PartSelect #: PS464532
Manufacturer #: 5303305677
A filter-drier in a refrigerator has two essential functions. The first is to absorb system contaminants, such as water, which can create acids. The second is to provide physical filtration. This mean...
$26.28
  In Stock
SWITCH – Part Number: 216822900
SWITCH
★★★★★
★★★★★
(2)
PartSelect #: PS427069
Manufacturer #: 216822900
This part turns the light on/off as the door opens and closes.
$60.17
  In Stock
Drain Plug – Part Number: 297013600
Drain Plug
★★★★★
★★★★★
(1)
PartSelect #: PS977294
Manufacturer #: 297013600
$8.27
  In Stock
Light Bulb - 25 watt – Part Number: 216846400
Light Bulb - 25 watt
PartSelect #: PS648941
Manufacturer #: 216846400
This bulb can be used in either refrigerator or oven. It is a clear, intermediate screw-in bulb.
$47.14
  In Stock

Questions And Answers for 25311531101

We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.

Common Symptoms of the 25311531101

[Viewing 6 of 6]
Won’t start
Fixed by
these parts
Show All
Will Not Start
Fixed by
these parts
Show All
Too warm
Fixed by
these parts
Show All
Frost buildup
Fixed by
these parts
Show All
Freezer section too warm
Fixed by
these parts
Show All
Fridge too warm
Fixed by
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Faulty Controller and Possibly Capacitor
After building a test box and determining the Controller was bad simply ordered parts and installed. Installation was a little difficult due to locking spades on electrical connections.

Unplug all power from freezer. Remove Bail wire from controller capacitor unit and remove from compressor by pulling STRAIGHT from compressor body to avoid bending contacts.

Use a very small instrumentation screwdriver to release locking spade on yellow and white wires. To unlock slide screwdriver in slot along wire entry to controller body while gently pulling on wire. Note position of wires and replace on new unit in same position/order. Plug new run capacitor into new controller being careful to orient capacitor to proper position (hole matches guide on controller unit). Plug newly installed controller and capacitor into condensor and replace bail wire.

Make sure timer is not in defrost mode - manually advance timer if necessary to ensure timer is in run mode. Turn temperature control to coldest setting. Plug in and hopefully enjoy the humming noise of your newly repaired and operational compressor and freezer.
Parts Used:
Run Capacitor Compressor Relay and Overload
  • eric from inglewood, TN
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers, Screw drivers
33 of 39 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
needed baskets for single items
I bought the freezer second hand, When I really started using it all the time it was inconvenient for the single items to reach down in three feet of larger frozen items.

I went to a store to see about getting a basket, They told me the next time I was there, get them the model number and they would see what they could do.

I just came home and got the model number and put name of the freezer in the search engine, Bingo it was done and I win.

Only took a couple days and my new basket was here. I am so pleased I ordered a second one.
Parts Used:
Upper Freezer Basket - White
  • Roberta from Winnfield, LA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
31 of 43 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Door gasket needed to be replaced.
I removed all of the expandable pins that held the gasket and the inner door panel, and removed the old gasket from the inner door panel. The new gasket was then placed around the edges of the inner panel. While holding the gasket and panel in the proper location, the expandable pins were inserted into the mounting holes, finishing the installation.
Parts Used:
GASKET-DOOR
  • Arnold from Quincy, IL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
18 of 26 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!