This 8 inch surface burner with reinforced delta frame carries 2100 watts and 240 volts. It has five turns and is compatible with many electric ranges. Its center medallion is all black in color.
This is a delta frame surface unit, also known as coil element, for a stove, range, or oven. It is a 6-inch surface burner with a reinforced delta frame that carries 1250 watts and 240 volts. The burner has four turns and is compatible with many electric ranges. The center medallion is black in color. The burner provides heat to your cook...Read moreing area to cook your food items. If your burner is not heating properly, you may need to replace it. Be sure to disconnect power to the appliance before completing this repair.
This trim ring is intended for use with many electric ranges. It is a chrome trim ring that is used with six inch surface burner elements. Notes The matching eight inch chrome trim ring is available with part number PS120222.
This is a blower motor for your range, but you may also know it as a blower fan motor or a downdraft vent fan motor. This part is used with down draft models. It helps draw the steam and odors through the vent for the stove top when the switch is activated. The blower motor has a diameter of five inches. The shaft on this model has a 3/8-...Read moreinch diameter with a counter clockwise rotation. This motor includes the foam seal.
This blower wheel attaches to the ventilation motor to draw in and exhaust smoke, steam, and cooking vapors, helping maintain clean airflow in your kitchen. Built from durable metal for heat resistance and long-lasting performance, it measures approximately 7 inches in diameter and under 4 inches deep for a secure, efficient fit. Designed...Read more to spin smoothly on the motor shaft, replacing a worn or damaged blower wheel can restore proper airflow, reduce noise, and ensure reliable ventilation performance.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
bad element control switch
12 of 16 peoplefound this instruction helpful.
Richard from Beverly Hills, CA
Easy
15 - 30 mins
Pliers, Screw drivers, Wrench set
1. Turn off power to range at circuit breaker 2. Remove grate 3 Remove control knobs 4, Remove two screws holding control panel 5. With wrench, remove locking nuts from control switches 6. Lift panel, exposing switches 7. With new switch in hand, unattach old switch one terminal at a time, attaching new swi
... Read moretch exactly as old switch, terminal by terminal. 8. Replace everything in reverse order 9.Turn on power
Read less
Was this helpful?
Thank you for voting!
Motor bearing failure after 34 years.
9 of 9 peoplefound this instruction helpful.
Wade from CARMINE, TX
Really Easy
1- 2 hours
Nutdriver, Screw drivers
Important: Down load the helpful assembly diagram for the fan motor and study it for a few minutes. It's very straight forward. Also a good idea is to remove the bottom panel which comes off easy before starting.
My only problem was removing the existing blower/fan wheel without damaging it once I had the assembly on the work b
... Read moreench. It was rusted on tight and managed to remove after a few tries using penetrating oil. The wheel is in stock and I'd suggest buying a new one along with the new motor if I had to do the job again.
Bottom line; the fan motor fit perfect but did have to re-use part of the old existing electric pig tail because the motor does not come with the factory type motor terminal connectors. By using three twist on wire connectors was back in business. The down draft vent works like new.