245032 (Series A) Graco Sprayer - Overview

This genuine item is supplied directly from the original equipment manufacturer for use with Graco paint sprayers. The o-ring fits between the housing and the filter and is made out of plastic. During the installation process, a screwdriver may be needed. This is available as an individual replacement part.

This is a genuine OEM sourced part which is specially designed for use with Graco sprayers. It is an identical replacement for a missing or a faulty threaded deflector that was included with a new unit, please make sure to refer to the owners manual and the appropriate diagrams of your model for the correct location and application of thi...Read mores component. Keep in mind this high-quality item is made of durable material and is sold individually.

This is the return hose assembly, or return line, which is designed for various models of airless paint sprayers and is sold as an individual part. The return line is designed to allow paint and pressure to be returned into the reservoir, and simultaneously connected to a specific port on the sprayer for a continuous paint cycle. This ret...Read moreurn line is comprised of a high-quality rubber and metal pump attachment at one end and a metal tube and plastic reservoir attachment at the other end. Depending on your model, you may need a set of pliers or a wrench to disconnect and remove the old line. Before you replace your old line, it is recommended that you wrap the metal end of the line with Teflon tape to create the best seal possible. When replacing the line, disconnect the sprayer from power and release any pressure in the spray gun by squeezing it until no more pressure is felt.

The OEM Gasket is a grey foam part used to provide a seal between two joining pieces. If broken, there will be a leak and the part should be replaced. Refer to your make, model and diagram to check if this is the correct part for you.

This transducer is sourced from the original manufacturer for use in paint sprayers. The transducer, also known as a pressure transducer or pressure sensor, is responsible for monitoring and measuring the pressure of the paint being sprayed. The transducer then relays this information to the control system which allows the sprayer to rema...Read morein in the desired spray parameters and prevent over pressurization. Transducers can fail due to electrical issues, or mechanical damage, which can cause inaccurate pressure readings, loss of control, inconsistent spray patterns, poor paint application and fluctuating pressure rates. To remove a faulty transducer first, disconnect the electrical wires and fasteners holding it in place. Position the new transducer in the empty slot and reattach the electrical connections and any mounting hardware to complete your repair.

This replacement gear case insulator is supplied directly from the original equipment manufacturer for use with Graco sprayers. It is an identical substitution for a worn or missing filter that helps to remove the dust and other harmful contaminants from the material. Please make sure to refer to the owners manual for the correct applicat...Read moreion of this component. Keep in mind this high-quality 60 mesh filter is made of durable material and is sold individually.

This is a genuine Graco replacement part. The gasket is designed by the manufacturer for use in paint sprayers. This part is made of pliable rubber, and is used to seal the connection between the hose and the roller brush assembly. No tools are required when replacing this item. Simply remove the old part and slot the new one into place. This part is sold individually.