245-634-3 MTD Log Splitter - Overview

This genuine drive belt is an original replacement part sourced directly from the manufacturer and is commonly used in Craftsman lawn mowers and edgers. Made from flexible rubber, it transfers power from the engine to the pulley that drives the cutting blades. Over time, the belt may become brittle or cracked due to wear and exposure, req...Read moreuiring replacement to maintain optimal performance. Measuring 3L x 35.80 inches, this belt is sold individually. A wrench may be needed for installation, depending on your equipment model.

This is an original replacement part sourced directly from the manufacturer. The screw is commonly found in yard equipment from Craftsman, such as lawn tractors, snow blowers, and edgers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different screws...Read more used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You will require a wrench when replacing this item. The screw is sold as an individual replacement part.

Sourced directly from the original manufacturer, this Bell Washer is made of gold-colored metal and is sold individually, not as part of a kit or assembly. It is used to provide spacing between various part assemblies along a shaft. If you hear a strange noise coming from the shaft area, or you notice the Washer is visibly worn or damag...Read moreed, it will need to be replaced. Refer to your owners manual to determine the exact location of this part. Customers rate the difficulty of this repair as Medium.

This silver metal lock washer helps prevent the nut on the drive belt pulley shaft from backing off during operation, it has a 5/16-inch inner diameter and a 1/2-inch outer diameter. one washer is included, replace it if fatigue or damage allows the connected shafts to spin freely, verify fit using the equipment model or owner manual

The Push Cap is a black plastic cap which secures to the end of a shaft to prevent injury. It can be installed with a hammer and is rated as "Easy" to install. If the part appears damaged or worn down in a way that could cause injury, it should be replaced. Refer to your make, model and diagrams to check if this is the right part for you.

This metal shoulder screw has a 0.498-inch-wide shoulder that is 0.340 inch long. It can act as a pivot or guide for moving parts on select lawn and garden machines. Replace it if the shoulder, threads, or head are worn or bent. Use the full equipment model number to guarantee the proper fit. Check the parts diagram for its exact location and install all washers and spacers in the correct order.

This OEM Hex Nut 5/16-24 is a silver, metal nut. This certified part is sold individually. It can be applied with a Wrench or Socket and Torque Wrench to the bracket on the rear of the auger house to secure a bracket to the back of the auger housing. Simply torque to the manufacturer specifications. Refer to your owners manual to find o...Read moreut if this is the part you need. Over time the part may be damaged by fatigue and will come loose due to damaged threads, at which time it should be replaced.

This OEM Hex Nut is a gold colored, metal, 3/8 x 16 part, sold individually. It is installed with a wrench, or socket and torque wrench, by torquing to the manufacturer specfications, and is used to secure parts in place. You will know it is broken when you see the nut has damaged threads or rounded off edges, which can happen due to fa...Read moretgiue. If it is damaged, it should be replaced. This part can have different uses and different degrees of difficulty depending on the part the hex nut is securing, but generally the replacement of this part is an easy job.

This is an authentic OEM component from Ryobi. The hex bolt (5/16-18 x .1in. lg., gr.5) compatible with many lawn tractors, helping to secure the steering gear assembly. The metal hex bolt is sold individually, and a wrench is required for the replacement.