2414 (Type 2) Makita Chop Saw - Overview

This is an authentic Makita replacement part that has been sourced from the original manufacturer and is intended to be used with chop saws and cut-off saws. The vice nut fits into the screw guide and is used to fasten the vice screw. This item is available as an individual replacement part.

This part is available individually. The spring washer fits between the wing nut and the flat washer. This washer is small and will need to be replaced if it gets lost or if it breaks. It is made out of metal and no tools should be necessary when replacing this item. This is an OEM Makita part directly sourced from the manufacturer for use with saws, cutters, planers, drills, and trimmers.

An authentic item which is supplied directly from the original equipment manufacturer for use with Makita saws. It is an identical replacement for a missing or damaged cushion which was originally installed on a new unit, the part is secured on the bottom of the base in order to provide support and help reduce vibrations from a working mo...Read moretor. This high-quality component is made of durable rubber material and is sold individually, keep in mind the hardware to secure it is sold separately.

This is a genuine Makita replacement part that includes two carbon brushes with wire leads attached. Carbon brushes are essential components in power tools and are among the most commonly replaced parts due to regular wear from friction. Over time, worn brushes can cause a motor to run poorly, operate intermittently, or lose electric brak...Read moreing power. Replacing them can often restore your tool’s performance. A worn brush may appear cracked, pitted, burned, or worn down near the wire lead. It’s always best to replace both brushes at the same time, even if only one shows signs of wear. When installing new brushes, be sure to inspect the armature for any damage such as burns or cracks, which could indicate more serious motor issues.

Genuine Makita replacement part, this item is sold individually. The purpose of the Brush Holder Cap is to retain the brush in the brush holder. This Brush Cap is used on all the Makita models listed below. It is removed by using a slotted screwdriver Do not press too hard when removing the cap they do have a tendency to break.

This cord is a genuine Makita replacement part and is sold individually. It is constructed with tough, thick outer rubber insulation for a long service life. Power Cord Specifications: • 3 Prongs • 3 Wires • 16 Gauge • 8 Feet Long

This ring (15.8) is supplied directly from the original equipment manufacturer. The metal ring is designed to help secure the blade in the various miter saw devices. A screwdriver and a wrench are often necessary for the removal and replacement. The ring is sold individually.

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Makita power tools. It is an identical replacement for a missing or damaged rubber pin that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and applicat...Read moreion of this hardware. Keep in mind this high-quality item is made of durable rubber material and is sold individually.

This is an authentic part from Makita for use in chop saws and cut-off saws. The screw guide attaches to the base and is made of metal. When replacing this item a wrench set might be required during the installation process. It will require replacing if it becomes broken. This part is available as an individual replacement.

This replacement switch is a genuine item sourced directly from manufacturer. It is an important item that handles on and off function of a unit, allowing user to control the tool. Switches have moving mechanical parts. These parts will eventually break down and fail requiring replacement. Please note the switch is sold individually. Rep...Read morelacing this item is a simple task that should only require a screwdriver. • Remove the housing screws • Remove housing/cover • Disconnect wires from the old switch • Replace old switch with a new one • Reconnect wires • Reassemble and test the unit