232901 Graco Sprayer - Overview

This is an authentic manufacturer sourced replacement part that is designed for use with Graco paint sprayers. It is utilized to create an air tight seal for the inlet housing that is part of the pump, for correct application make sure to check appropriate diagrams of your model. Over time the material may deteriorate and crack eventually...Read more requiring replacement to maintain peak performance. It is made from durable rubber material and it is sold individually.

This genuine item is supplied directly from the original equipment manufacturer for use with Graco paint sprayers. The o-ring fits between the housing and the filter and is made out of plastic. During the installation process, a screwdriver may be needed. This is available as an individual replacement part.

This is a genuine OEM sourced part which is specially designed for use with Graco sprayers. It is an identical replacement for a missing or a faulty threaded deflector that was included with a new unit, please make sure to refer to the owners manual and the appropriate diagrams of your model for the correct location and application of thi...Read mores component. Keep in mind this high-quality item is made of durable material and is sold individually.

This is the return hose assembly, or return line, which is designed for various models of airless paint sprayers and is sold as an individual part. The return line is designed to allow paint and pressure to be returned into the reservoir, and simultaneously connected to a specific port on the sprayer for a continuous paint cycle. This ret...Read moreurn line is comprised of a high-quality rubber and metal pump attachment at one end and a metal tube and plastic reservoir attachment at the other end. Depending on your model, you may need a set of pliers or a wrench to disconnect and remove the old line. Before you replace your old line, it is recommended that you wrap the metal end of the line with Teflon tape to create the best seal possible. When replacing the line, disconnect the sprayer from power and release any pressure in the spray gun by squeezing it until no more pressure is felt.

This is an authentic OEM part. The Graco switch is constructed of metal and plastic, and is made for use with many paint sprayers. This component is fitted onto the control box and wired to the control panel. The switch controls the power for many small, airless paint sprayers. A screwdriver and a wrench are helpful in making the replacement. The switch is sold individually.

This transducer is sourced from the original manufacturer for use in paint sprayers. The transducer, also known as a pressure transducer or pressure sensor, is responsible for monitoring and measuring the pressure of the paint being sprayed. The transducer then relays this information to the control system which allows the sprayer to rema...Read morein in the desired spray parameters and prevent over pressurization. Transducers can fail due to electrical issues, or mechanical damage, which can cause inaccurate pressure readings, loss of control, inconsistent spray patterns, poor paint application and fluctuating pressure rates. To remove a faulty transducer first, disconnect the electrical wires and fasteners holding it in place. Position the new transducer in the empty slot and reattach the electrical connections and any mounting hardware to complete your repair.

This is an original manufacturer-sourced part which is designed for Graco sprayers. The base helps to secure the drain valve. If it is missing or is damaged, it will provide an identical replacement for the original component that was installed on a new unit. Refer to the owner's manual and the appropriate diagrams for the correct applica...Read moretion and replacement procedure. Note, this high-quality valve base is made of a durable plastic and is sold individually.