226H Husqvarna - Overview

This is a genuine part that is sourced directly from the original equipment manufacturer for use with Husqvarna walk-behind lawn mowers. The idler pulley applies tension on the drive belt. It is an identical replacement for a damaged or a missing component that was installed on a new unit. One durable idler pulley with pre-installed beari...Read morengs is included. Check the diagrams of your model for the exact location and the correct installation of the new item. You will need a wrench set to remove the old pulley and secure the new one.

The Dust Shield is a 6-3/4 inch, black plastic part, used to prevent dust or debris fouling the wheel or axle. It attaches inside of the wheel around the axle. Installation is rated as "Easy" and will require a wrench. If broken, damaged, or worn due to fatigue, you will see visable damage and you may have debris getting caught in the axl...Read moree. If broken, replace it. Refer to your make, model and diagram to make sure you're choosing the right part. This part comes individually sold.

This drive belt transfers power between rotating components to support motion and operation. Built for strength and flexibility, it helps ensure smooth power transmission and dependable performance.

Made of high-quality metal, this hex flange locknut is designed for use with various lawn mowers and ride-on mower/tractor models and is sold individually. This locknut attaches to the end of the carriage bolt and is an important component to the axle assembly. This locknut has a 3/8-inch inner-diameter and is 16 threads-per-inch. To repl...Read moreace this locknut, you will need a wrench, and if there are multiple locknuts on your equipment, they may all need to be replaced.

The E-Ring 7/16 is a 7/16-inch silver, metal part which can be attached to various locations on a variety of equipment to snap into grooves and secure parts into place. This part will require pliers to install. If broken, damaged or worn, there may be a problem with the part it is securing and the part should be replaced. Refer to your make, model and diagrams to check if this is the right part.

This part has been sourced from the original manufacturer and is intended to be used with walk-behind lawnmowers from Husqvarna, Poulan, Weed Eater, and Jonsered. The metal pawl is used to secure the pinion to the transmission axle to allow the two parts to rotate in unison. This drive pawl is priced as a single item, please note two may be needed.

This is a genuine Craftsman part for use with Lawn Mowers. The drive gear attaches on the inner side of the drive wheel. The drive gear meshes with the pinion in the drive wheel to propel the mower. The most common reason for replacing the gear is when the self-propel system will not drive one or both wheels. This part is sold individuall...Read morey. The tools that you will need to replace the gear is a 12mm socket and snap-ring pliers.

This replacement wheel is a genuine manufacturer sourced item that is specially produced for Husqvarna lawn mowers. This is the rear drive wheel that is driven by the transmission assembly. It is made from durable plastic and it is sold individually. Please note that the hardware to secure it, gears, and other parts are all sold separately.

It is a genuine item that is supplied directly from the original equipment manufacturer for Husqvarna lawn mowers. This is a high-quality replacement for a missing or damaged tension spring that was installed on a new unit. Please make sure to check the appropriate diagrams of your model for the correct location and application of this ha...Read morerdware. Keep in mind this tension spring is made of durable metal and is sold individually.