226A Coleman Lighting - Overview

Neoprene Pump Cup

This is an authentic manufacturer sourced replacement part used on Coleman gas lanterns. This globe is made out of clear glass, and it is sold individually. Lantern globe can be installed easily with no tools.

These authentic Coleman #20 mantles are used with the 222, 226, 229, and 3022 lantern models. These mantles have a string-tie attachment style; simply tie them to the fittings and they are ready to use. These mantles must be primed before the lantern is used. Note that they will be extremely fragile after this pre-burning step; it is reco...Read moremmended to keep extra mantles in case of damage. This listing is for one pack of two mantles.

This is a manufacturer-sourced replacement part designed for fuel tanks used with Coleman heaters and lanterns. This filler cap covers a valve opening on the tank that is found as part # 424-5601. This metal part is sold individually.

This genuine Coleman-made lubricant is used on the pump in the gas lanterns. This part assists in creating an air tight seal inside of the pump. Inside the pump is a leather or neoprene pump cup; the pump cup needs to be coated in lubricant in order to seal it effectively. This lube is made of neatsfoot oil, a thin animal oil primarily used to condition and soften leather. This part is sold individually.

This is a genuine Coleman maintenance kit used with the 222, 226, 229, and 3022 series of portable lanterns. It includes one each of the most commonly replaced lantern parts: generator, neoprene rubber pump cup, and push-on nut. Note that the generator itself is sold individually as part # 226-2991. Installation instructions are printed o...Read moren the back of the package as well as below. Installation Instructions: Pump Cup Replacement: • Unlock old pump from tank by turning cap. • Pull out pump from tank. • Carefully remove and replace old push-on nut and pump cup with the new parts. • Install new pump into tank, being careful not to invert or damage pump cup. Generator Assembly Replacement: • Move away from any ignition source. • Release any pressure from tank by loosening filler cap from tank and then retightening. • Turn fuel valve to off position. Remove bail, ventilator, glass globe, and heat shield. • Unscrew frame nut and lift frame from lantern. • Remove base rest. Hold valve with wrench and unscrew jamb nut at bottom of generator. • Lift generator and unhook cleaning rod. • On new generator, pull cleaning rod down about 1/4". Hold cleaning rod between thumb and forefinger with generator in upright position. • Slide old jamb nut over top of generator. • Hook cleaning rod into valve and turn fuel valve to "on". Carefully lower generator to avoid bending cleaning needle. Tighten jamb nut finger-tight. • Replace base rest and frame onto lantern, making sure that end of generator enters opening in burner. Tighten frame nut securely. • Using a wrench, tighten jamb nut firmly to form leak-tight joint. Avoid stripping threads. • Replace heat shield. Check mantle for damage and replace if necessary. • Replace globe, ventilator, and bail. Visually check for leak immediately after lighting.

This authentic Coleman replacement plunger is made for use with liquid-fueled lanterns. This part features a plastic pump cap. Note that the Check Stem and Valve Assembly is sold separately as part #: 400-6381.