My Orders
22114 Jenn-Air Cooktop - Overview
Diagrams for 22114
See every part. Know exactly what you need.
Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".
Search filter:
Clear Filter
Your search term must have 3 or more characters.
$21.45
In Stock
Screw
Part #W11233072
This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.
$7.47
In Stock
$74.08
In Stock
Infinite Switch
Part #W11120795
The surface element control switch is an essential component in electric ranges, responsible for regulating the heat output of the surface burner. It allows you to adjust the temperature levels by controlling the electrical flow to the burner. If your stovetop burner fails to turn on, stays on high heat, or doesn’t respond to adjustments,...Read more a faulty switch could be the cause. This switch features a double flat shaft design and is nut-mounted for secure installation. Always disconnect the power supply before replacing the switch to prevent electrical hazards. Ensure compatibility with your appliance model before purchasing.
Read less
$77.65
In Stock
Surface Burner Knob Kit
Part #12200035
This set of four burner knobs helps control the heat on a range or cooktop. Each knob fits a double-flat control shaft and shows the burner settings clearly. Replace the knobs if they are cracked, loose, worn, or missing. Before ordering, inspect each shaft for bending or damage. A new knob will not fix a bad burner switch. Confirm fit wi...Read moreth the full appliance model and shaft shape. Turn every control to Off, disconnect power, pull the old knobs straight off, and press the new ones on without force. Check that each pointer lines up correctly.
Read less
$49.50
Special Order
No Longer Available
$55.29
On Order
Range Glass Grease Collecting Jar
Part #WPY707869
This jar is a little over five inches long. It is made of glass and is used for collecting the grease drippings of gas ranges.
$54.24
In Stock
Range Cartridge Receptacle
Part #WPY702434
This cartridge receptacle is almost four inches long. It is white in color and is made of ceramic.
$53.20
In Stock
Range Burner Cartridge Terminal Block
Part #WPY708730
No spades or wiring come with this part. To order the spades or wiring, please research by model# of appliance.
$7.47
In Stock
No Longer Available
Drain Jar Lid
Part #WP5700M611-60
This grease jar lid is used for some of Maytag/Jenn-Air's brands of ranges and cooktops. This lid is not quite an inch high and is three inches in diameter.
$8.55
Special Order
Exact Part matches for your search term
No Longer Available
No Longer Available
No Longer Available
Common Symptoms of the 22114
How this model fails, and the parts that fix it.
Element will not heat
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Touchpad does not respond
Fixed by
these parts
these parts
Show All
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!
View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Infinite switch ran more than one burner
33 of 61 people
found this instruction helpful.
Purchased 1 infinite switch and installed it on the left front burner. problem still there so I used the switch that I replaced on the rear burner and all was ok. The front switch had been sending full heat to the rear burner,but the problem ended up with the rear switch. The switches are interconnected and all are the same part number.Di
... Read more
agrams on partsselect were the key to a successful repair.To access the switch you need only to remove the fan cover, remove the 2 screws holding the switch assembly and move it foreward and then lift to reveal slide on connectors. Power to the unit is off at the main panel during the entire process.
Read less
Other Parts Used:
Was this helpful?
Thank you for voting!