21A-447-190 (1998) MTD Tiller - Overview

This is an original replacement part sourced directly from the manufacturer. The screw is commonly found in yard equipment from Craftsman, such as lawn tractors, snow blowers, and edgers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different screws...Read more used in the machine. Refer to the parts diagram to be sure of ordering the correct part. You will require a wrench when replacing this item. The screw is sold as an individual replacement part.

The Jamlock Nut is a 3/8-16 inch metal nut which can be installed using a socket or wrench set. It's used to secure and lock parts in place. If the part is damaged and comes loose it should be replaced. This is an authentic part authorized by the manufacturer.

This silver metal lock washer helps prevent the nut on the drive belt pulley shaft from backing off during operation, it has a 5/16-inch inner diameter and a 1/2-inch outer diameter. one washer is included, replace it if fatigue or damage allows the connected shafts to spin freely, verify fit using the equipment model or owner manual

The air valve attaches to the wheel and is made of a durable material. This is a genuine MTD, Ryobi, Yard Machines, Bolens, Troy-Bilt, and Yard Man part sourced directly from the manufacturer for use in chippers, shredders, cultivators, edgers, lawn tractors, snowblowers, and trimmers. Keep in mind that this part is sold individually. Whe...Read moren replacing this item a set of pliers might be required during the installation process. It might wear out over time and will need replacing.

This Flat Washer is made of durable gold-colored metal and is an authentic OEM part. It is used to spread the load under a bolt or nut and is sold individually. This part will need to be replaced if you notice any signs of cupping, corrosion, or other damage. Customers rate this repair as Easy.

This is an authentic replacement part manufactured for use with garden tillers. The shaft seal is used to seal the connection where the gear shaft connects to the gearbox housing. This shaft seal is sold as an individual replacement part, please see model diagram for associative parts.

This is a genuine OEM sourced replacement screw which is commonly utilized on lawn and garden equipment. It is a standard hardware which has multiple applications based on the model of your unit, please refer to appropriate diagrams for the correct location and use of this part. It is a high-quality hex head screw which is made of durable...Read more metal and it is sold individually. Over time threads may wear out or it may simply get lost eventually requiring a replacement, note that a wrench will be needed to install or remove this hardware.

This is an authentic MTD tiller replacement part. The hex B-tap screw is used to fasten the cable barrel holder to the clutch lever to ensure good tension on the clutch cable. The part is made of durable metal. You will need a wrench to replace this piece. This item is sold individually.

This Bell-Wash Flat Washer is an OEM part that measures .40 inches I.D. x 88 inches O.D. This washer is a silver, metal, washer sold individually. This part is rated as Easy to install by customers. If missing or damaged (likely due to fatigue) it should be replaced. Refer to your owners manual to ensure this is the correct part for you.