2034-10 (Type 2) Black and Decker Electric Drill - Overview

Genuine Dewalt replacement part, this item is sold individually. The 696631-00 Steel Ball is part of the chuck assembly of the Impact Drivers shown below. When you pull back the sleeve of the chuck assembly and insert your bit, the Steel Ball is the part that locks the bit in the chuck assembly. In the Screw Drivers listed below this is the part that secures the Bit Holder in the spindle.

It is a genuine replacement screw that is sourced directly from original equipment manufacturer. This is a standard hardware that has multiple uses depending your tool. For correct location and use of this screw, please check appropriate diagrams. This torx screw is sold individually.

Genuine OEM replacement part, this item is sold individually. This screw is used in various places in all of the tools listed below The most common use for this screw is to secure plastic housings together. It has a Torx T-20 head.

This genuine cord protector, also known as a strain relief boot, is designed to safeguard the power cord where it enters your tool housing. Made from flexible, durable material, it helps prevent the cord from bending, twisting, or fraying during regular use, supporting safe and reliable performance. Small but essential, this component is ...Read morean effective replacement if the original protector is worn or damaged, helping extend the life of your tool and maintain proper cord alignment.

Included in part number 944825-00

Included in part number 385476-00

This retainer, also known as a retaining ring or split ring, is a genuine OEM replacement part used in cordless drills. It is responsible for securing the spindle within the clutch housing so that it remains stable during use and ensuring the components such as gears and bearings do not slide off the spindle. Over time the retainer may cr...Read moreack, corrode, or fall off, leading to wobbly parts and excessive vibration. Ensure the drill is off before beginning the replacement. Remove the chuck, and clutch housing. Use a set of pliers to remove the retainer from its groove. Clean the mounting surface and place the new ring in the groove on the spindle. Reassemble the drill components in reverse order.