2000007 Coleman - Overview

This is a genuine Coleman kit made for repairing tent roof poles. It fits either the side roof pole or the main roof pole, found as part # 5010000549. This kit includes five fiberglass pole sections, two metal end caps, two metal connector pieces, a fiberglass end piece, and the stretchy center shock cord. The fiberglass sections can be trimmed to size as needed.

This is a genuine Coleman replacement tent pole. This is a standard-style tent pole made of fiberglass material. Includes five sections, one shock cord, and two vinyl end caps. The repair kit for this pole is found under part # 5010000539. This part will require light assembly before use.

This authentic OEM Coleman kit is for one individual tent pole. This is a fiberglass pole with an 8.5mm diameter. This kit includes five 30" pole sections, two vinyl end caps, six attached metal ferrules, and a 10' shock cord. This kit will require light assembly before use.

Please add that once these are put together comes out 130" due to ferrules/

This is a genuine Coleman kit made for tents. These are fiberglass poles that can be cut to size if needed. This kit includes five pole sections, two vinyl end caps, two metal end tips, and one 11ft shock cord.

This is an authentic Coleman-made tent pole repair kit. It includes five pole sections, two vinyl end caps, two metal end tips, and a 14' shock cord (used inside the poles). The pole sections have a 9.5mm diameter. It requires some light assembly before use.

This is a genuine Coleman-made lantern part. This part is also called the Lower Mantle Support. The brass cylinder of this part aligns with the brass cylinder of the burner assembly; each end of the tube-shaped Mantle (part # 95-132C) fits around one of the cylinders. The shield portion of this part sits below the mantle and flame, protec...Read moreting the lower fuel areas from heat and errant flames. This part is sold individually.

This is a genuine Coleman replacement globe made for the Perfectflow Instastart Lantern. It is a transparent glass piece that is specially designed to withstand heat. This part is sturdy but the manufacturer recommends transporting and storing the lantern in a hard case to keep both the globe and the mantles protected. This part is sold i...Read morendividually. To Replace This Part: • Unscrew the Nut (Part #: 5010000812) located at the very top of the lantern; it should be possible to remove this part just by hand, without any tools • Lift the Ventilator Lid (Part #: 5010000812) to remove it • Lift the old globe to remove it; set the new globe into place • Replace the Ventilator Lid and Nut

This is a genuine replacement burner used with the Perfectflow 2-Burner Propane Stove. This part is screwed hand-tight onto the manifold. The fuel passes from the manifold into the body of the burner, escaping from the perforations circling the edge where it is lit. This is a one-piece part that is sold individually.

This is an OEM cord sourced directly from Coleman for use with the Hot Water On Demand portable water heater. This is a 12-volt car charging cord that is used to recharge the battery. This cord is designed to fit inside the storage compartment on the heater. It is sold individually.

This is an authentic replacement cord which is sourced directly from the original equipment manufacturer for use with Coleman Hot Water On Demand portable water heaters. It is an identical replacement for a lost or damaged component that came with the new unit, please note this high-quality transformer cord is sold individually.