20-2 Delta - Overview

Genuine Delta replacement part, this item is sold individually. The purpose of the is nut is to secure the blade of the Table Saw to the Saw Arbor. It is a left hand ACME thread. It is used on all of the right tilting Table Saws listed below.

The key attaches to the shaft and is made out of metal. This item is available individually. This is a genuine replacement part sourced from the original manufacturer for use with saws, drills, jointers, and shapers made by Delta. When replacing this part a set of pliers might be required during the installation process. It will require replacing if it becomes bent or broken.

This is an authentic manufacturer-supplied part which is specially made for Delta equipment. It is one of the special screws utilized to secure the nameplate. Please refer to appropriate diagrams of your model for the exact location and use of this hardware. This high-quality drive screw is made of durable metal and is sold individually. ...Read moreNote, the screw is installed into a pre-drilled hole. You will need a hammer to secure this component.

This special nut is priced individually and fits next to the lock washer. It is made out of metal and will need to be replaced if it becomes stripped or broken. A wrench will be needed during the installation of this part. The nut is an authentic part from Delta to be used in drill presses.

This is a genuine manufacturer sourced replacement part used on Delta and Black and Decker equipment. It helps to distribute the pressure evenly and provide a tight seal between connected components. This is a standard hardware which may have multiple applications. For the exact location please refer to the diagrams of your specific model. This part is made of high-quality metal and is sold individually.

This part is an OEM from Delta. The steel washer is compatible with a wide variety of power tools. This item distributes even pressure over the surface and provides a solid grip for the bolt or screw. This part is sold individually. A screwdriver and a wrench are often needed to make the proper removal and replacement.