1AKB6 Campbell Hausfeld Compressor - Overview

This replacement regulator/manifold manifold assembly is specially manufactured for Campbell Hausfeld air compressors. The manifold kit consists of the manifold, the regulator, two pressure gauges, two quick-disconnects, and the nipple that connects the entire assembly to the air tank. The manifold kit will solve any problems related to a...Read more cracked manifold assembly, as well as any problems with the regulator. To complete this repair job correctly you may need : Phillip's screwdriver, hex drivers, long-nosed pliers, wrenches and heavy-duty wire cutters. • Depressurize the tank • Remove the manifold cover • Remove the pressure hose • Remove the pump assembly from the tank • Remove the manifold • Remove the manifold nipple • Transfer the safety valve • Install the new manifold kit • Secure the the pump assembly • Reinstall the hose • Reattach the manifold cover • Ensure everything is connected and test the compressor

The valve plate assembly fits between the cylinder and the cylinder head. This is available as a kit that contains the valve plate and two gaskets. These parts are OEM items sourced directly from the manufacturer for use in Campbell Hausfeld compressors. During the installation process, a socket set might be needed to replace these parts....Read more The valve plate is made of metal and the gaskets are made of a thin material. They will need to be replaced if they become broken.

This is an authentic OEM part. The 1/2 compression sleeve is compatible with many air compressor machines. With the compression nut, this item helps to secure the exhaust tube to the front shroud. An adjustable wrench is necessary for the replacement. The compression sleeve is sold individually.

This is a genuine Campbell Hausfeld replacement drain valve, sold individually. When using an air compressor, moisture naturally condenses inside the tank. If this water is left sitting for too long, it can lead to internal rust and damage. The drain valve allows you to release this built-up moisture easily. It's especially important to d...Read morerain your tank after each use—particularly if you tend to leave air in the tank for extended periods. Regular draining helps extend the life of your compressor and maintain its performance. Be sure to open the valve regularly to prevent water buildup and potential tank corrosion.

This genuine OEM replacement nipple is designed for use in air compressors, serving as a critical connector between the pressure switch, the tank, and the regulator. A damaged or corroded nipple can lead to air leaks and inconsistent pressure, affecting overall performance. To check for leaks, apply soapy water to the fittings around the ...Read morepressure switch and watch for bubbles. If replacement is necessary, the process typically involves disassembling the pressure switch. Begin by draining the tank using the valve at the bottom, then remove the coupler from the regulator and unthread the nipple. Access the wire connections by removing the pressure switch shroud, and carefully note the position of each wire before disconnecting them—starting with the motor wire, followed by the cord wires and ground wires. Remove the strain relief, pressure gauge, and the airline connecting the check valve to the switch. Finally, unthread the pressure switch from the tank nipple and remove the nipple itself. When reassembling, it is recommended to use thread tape to ensure a proper seal. This replacement part is sold individually.

This is a genuine Campbell Hausfeld replacement part that has been sourced from the original manufacturer to be used with air compressors. The oil level gauge attaches to the crankcase housing and is used to provide an indication of the amount of oil inside the case. This part is priced as a single item.

It is an authentic OEM sourced item which is specially produced for use with Campbell Hausfeld compressors. The air filter attaches to the cylinder head and is made of metal and plastic. A wrench might be necessary during the installation of this part. It may become dirty or broken and will need to be replaced. This is available as an individual replacement part.

This is a genuine Campbell Hausfeld replacement part. The gauge is designed by the manufacturer for use in air compressors. This is a complete assembly made primarily of high-quality plastic and metal, and it is placed in the pressure switch to monitor the pressure within the tank. This part is sold individually.