1988804830 Kenmore Ice Maker - Overview

Diagrams for 1988804830

See every part. Know exactly what you need.

Parts for the 1988804830

$18.22

Ice Maker Scoop

★★★★★

(4)

Part #W11420408

This ice maker scoop is an OEM refrigerator part designed to retrieve ice from the ice maker bin. It is made of plastic and measures approximately 10 3/4 inches in length and 4 inches in width. The scoop is designed to fit inside the ice bin for easy access. You will need to replace the scoop if it is cracked, broken, or lost. Discard the old scoop and insert the new one into its designated compartment.

$282.99

Ice Maker Water Pump and Motor

★★★★★

(2)

Part #WP756782

This part helps circulate water through the evaporator to form ice that will be cut into cubes.

$9.62

Speed Nut

Part #WP486692

The speed nut (also referred to as a condenser motor fan nut), fits onto the condenser fan motor. The motor for this fan turns on simultaneously with the evaporator and the compressor motors, so a malfunction in the condenser fan motor could cause your fridge to cycle on and off more frequently or run too warm, or too noisily. Make sure t...Read more

Read less

Ice Grid Cutter

Part #2174861

Used on freestanding ice makers.

Rivet

Part #WP596788

Sold individually.

$8.55

Screw

Part #WP486579

Sold individually.

Plug

Part #758597

Control Thermostat

★★★★★

(1)

Part #WP598235

This part helps prevent the evaporator from freezing over and also determines the thickness of the ice.

$44.23

Filter Drier Tube

Part #W10843121

This filter dryer is for refrigerators and filters refrigerant that travels through the sealed system of the refrigerator.

SCREW

Part #681534

Sold individually.

$21.45

Screw

★★★★★

(1)

Part #WPW10141625

Sold individually.

Condenser Fan Motor Kit

Part #978483

This motor operates the fan to help circulate the air for cooling of the compressor and the coils. It also helps to evaporate the excess water located in the drain pan.

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

The water pump broke (too old).

24 of 30 people found this instruction helpful.

NICOLAS from MCALLEN, TX
Easy
30 - 60 mins
Nutdriver, Socket set

I removed the three nuts that hold the old pump, easy. Next step was to replace with the new pump, tricky, because it goes real deep in the machine and my arms barely reach it.
After several attemtps, I finally reached one screw and bolt it immediately. Rest was piece of cake.
What I liked most, is that you don't need to do any ... Read more

Read less

Was this helpful?

Noisy

21 of 31 people found this instruction helpful.

Paul from Port Lavaca, TX
Easy
30 - 60 mins
Socket set

Easy to do.!

Was this helpful?

Ice machine grid cutter had failed. All necessary was to pull old one and replace with new one. Hardest part was to remove the cover face plate on the front of grid cutter. The rest was a piece of cake. Now my ice machine works perfect and produces a ton of ice quickly and nicely.

4 of 5 people found this instruction helpful.

Charles from Bryant, AR
Really Easy
15 - 30 mins
Pliers

I removed the two wing nut type screws and pulled grid cutter out and then disconnected both the electrical power plug and the light power plug. Then I removed the front face plate and put it on the new grid cutter after cleaning and re-inserted the new grid cutter into ice machine along with re-connecting the electrical and tighten wing ... Read more

Read less

Was this helpful?