1920 Little Wonder Hedge Trimmer - Overview

This authentic OEM supplied replacement part designed for use with Little Wonder electric hedge trimmers. This assembly includes one (1) carbon brush with a lead wire and a spring attached. Carbon brushes are a commonly replaced part on power tools. Due to constant contact and friction brushes will gradually wear down and will require re...Read moreplacement. It is advised to replace both brushes at the same type. You would need a screwdriver to complete this job. • Remove screws from the housing • Remove housing to gain access to brush holders • Remove the brush retaining plate and take out the old brush • Re-assemble and test the tool

This is a genuine OEM sourced replacement flange nut that is specially produced for Little Wonder electric hedge trimmers. This nut will resists loosening when properly threaded onto a bolt. It is generally used to secure the blades and the bar together. Please note, it is sold individually. You will need a wrench to tighten or loosen this flange nut.

This is a genuine Little Wonder replacement part that has been sourced from the original manufacturer to be used with hedge trimmers. The metal screw is used to secure the blades, guard, and bar. This screw is available as a single item, please note the nut is separate.

This is a genuine manufacturer-sourced replacement gasket which is specially designed for use with Little Wonder hedge trimmers. The part provides an air-tight seal between connected parts, please refer to the appropriate diagrams of your model for the correct location and application of this hardware. Over time the gasket may wear out an...Read mored begin to crack eventually requiring a replacement, keep in mind this high-quality composite material item is sold individually.

This is a genuine Little Wonder replacement part that has been sourced from the original manufacturer to be used with hedge trimmers. The two wire cord is wrapped in a durable covering and is used to relay electricity from the extension cord to the switch assembly. This item is available as an individual replacement part.

This is an original Little Wonder replacement part. The wear strip is designed by the manufacturer for use in hedge trimmers. This part is made of metal, and is used to hold the felt seal in place, and also to reduce the wear of the blades on the housing. You may require a screwdriver or Allen wrench when replacing this item. This part is sold individually.

Cluster Gears(includes Cluster And Eccentric Gear)

It is made of metal and is sold individually. The connecting link goes between the inside blade and the frame bar. A screwdriver might be helpful during the installation of this part. It will require replacing if it becomes broken or bent. This is an OEM part sourced directly from the manufacturer and used in trimmers made by Little Wonder.

This part is available as an individual replacement. The gear cluster is made out of metal. When replacing this item a wrench and a screwdriver may be needed. It will need to be replaced if it becomes stripped or broken. This is an authentic Little Wonder replacement part that is sourced from the original manufacturer for use with trimmers.