17E585 Graco Paint Sprayer - Overview

This OEM pneumatic wheel is connected to the frame or base of your sprayer, providing easy transportation over rough or uneven surfaces. This wheel is an 11-inch rubber tire on a 4 inch-rim filled with air and is mounted on a hub or axle. To identify a broken wheel, look for signs such as deflation, wobbling, or excessive wear and cracks....Read more Operating your sprayer may become challenging, and the paint application could become uneven. To replace a wheel, use a wrench or pliers to remove the axle cap or nut securing the wheel assembly. Afterwards, you can slide the wheel off the axle. Please note that this replacement part is sold individually, and it is recommended to replace all your wheels at once for optimal performance.

This part is available as an individual replacement. The cap attaches to the frame and is made out of plastic. A hammer may be necessary during the installation of this item. Over time this part may break and will need to be replaced. This item is an OEM from Graco for use in sprayers.

This is a genuine OEM sourced part which is specially designed for use with Graco sprayers. It is an identical replacement for a missing or a faulty threaded deflector that was included with a new unit, please make sure to refer to the owners manual and the appropriate diagrams of your model for the correct location and application of thi...Read mores component. Keep in mind this high-quality item is made of durable material and is sold individually.

This is the return hose assembly, or return line, which is designed for various models of airless paint sprayers and is sold as an individual part. The return line is designed to allow paint and pressure to be returned into the reservoir, and simultaneously connected to a specific port on the sprayer for a continuous paint cycle. This ret...Read moreurn line is comprised of a high-quality rubber and metal pump attachment at one end and a metal tube and plastic reservoir attachment at the other end. Depending on your model, you may need a set of pliers or a wrench to disconnect and remove the old line. Before you replace your old line, it is recommended that you wrap the metal end of the line with Teflon tape to create the best seal possible. When replacing the line, disconnect the sprayer from power and release any pressure in the spray gun by squeezing it until no more pressure is felt.

The packing o-ring fits between the displacement pump and the intake tube. This item is made of rubber and is available individually. This is a genuine Graco replacement part for use in sprayers. A set of pliers may be required to replace this part if it becomes broken.