1697108A-00 Snapper Lawn Tractor Accessories - Overview

The hair pin is a silver, metal pin used to secure and lock parts in place. If broken, the part being secured will come loose and the pin should be replaced. This is an OEM part directly from the manufacturer. Most customers rated the replacement of the hair pin as an easy repair.

BOLT, 5/16-18 x 3/4" Short Neck Carriage, GR 5

It is a genuine OEM sourced part that is specially produced for use with Murray and Snapper lawn and garden equipment. This is a standard hardware which may have multiple applications, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this component. This high-quality carriage ...Read morebolt is made of durable metal and is sold individually, keep in mind the washer and other parts are all sold separately.

The retainer attaches to the idler arm support. This genuine item is supplied by the original equipment manufacturer for use with tractors and rear engine riders made by Snapper, Murray, and Simplicity. It is made out of metal and is sold individually. During the installation process, a wrench set might be needed to replace this part. Over time this part may break and will need to be replaced.

Pin 5/16-x1.68

This is an authentic OEM sourced replacement part that is intended to be used with snowthrowers and lawnmowers from Murray, Snapper, and Simplicity. The metal nut is used to secure a bolt and the application of the nut can vary based on the model of equipment. It is recommended to review your model\\\'s illustrated part diagram to check the nut\\\'s compatibility and usage. This item is sold individually.

Latch Keeper

This is an authentic Snapper replacement part. The dust skirt is commonly found on riding mowers. This part is made of fabric, and is used to prevent grass clippings from flying out of the grass bag. You may require a wrench when replacing this part. This item is sold individually.

This 0.25-inch-diameter washer with internal lock teeth is an authentic manufacturer replacement fastener used in outdoor power equipment. It has a flanged base, which provides even load distribution and protects the mounting surface from damage during installation and removal. The washer also has inward-facing teeth, providing additional...Read more grip to prevent the secured components from falling off the equipment. Over time, the washer will corrode, crack, or wear down its teeth, leading to equipment instability, noise, and vibrations. Inspect all the washers in your equipment and replace those that are no longer functional. Use a wrench or socket to loosen and remove the old washer, and then position the new one on the mounting surface. Tighten the washer until the flange rests flush against the surface. Each washer is sold individually.

Bag rod asmy

This is an authentic Murray replacement part. The bolt is designed by the manufacturer for use in snow throwers and riding mowers. This part is made of metal, and may be found in various locations in the machine, depending on model. Please be aware that there are different bolts used in the machine. Refer to the parts diagram to be su...Read morere of ordering the correct part. You may require a wrench when replacing this part. This item is sold individually.