1692934 Simplicity Snow Blower - Overview

This is a genuine item that is supplied directly from the original equipment manufacturer for use with Murray, Snapper and Simplicity lawn and garden equipment. It is an identical replacement for a missing or damaged hold down that was originally installed on a new unit, please make sure to check the appropriate diagrams of your model for...Read more the correct location and application of this hardware. Keep in mind this high-quality component is made of durable black plastic and is sold individually.

The Oil Seal is used to seal the gear case where the axle extends from the case, around the axle shaft. It's rated as "Easy" to install, and will require a wrench set and seal puller. When installing, use something big enough to make contact with the entire seal, such as a PVC pipe, and tap gently into place. If broken, you will see oil ...Read moreleaking, and the part must be replaced. This gray, rubber part is sold individually. Refer to your make, model and diagrams to ensure this is the correct part for you.

BOLT, 5/16-18 x 3/4" Short Neck Carriage, GR 5

This is a genuine replacement part sourced from the original manufacturer for use with snowthrowers and lawnmowers. The special capscrew is used with several different models of equipment, and the application of the capscrew can vary based on the model of snowthrower or lawnmower. This capscrew is available as an individual replacement part, please see model diagram for associative parts.

This centerlock nut, also known as a flange nut or hex nut flange is a manufacturer approved replacement part. It is 5/8 of an inch with 18 threads per inch. The nut is designed to secure the bolt or screw it is positioned on and prevent it from loosening during use. It has a series of ridges on the inside that allow it to grip the thread...Read mores of the bolt or screw and a flange at its base to provide a larger surface area to clamp on. Over time the lock nut may break or become stripped. Inspect all the centerlock nuts on your equipment as you may need to order more than one for your repair. To install a new nut, use your hands to thread it on and use a pair of pliers or a wrench to tighten it until it is securely held. Be careful not to overtighten the nut as this can deform the nut and wear down the threads that keep it secure. If you experience difficulties removing or tightening the nuts, use a centerlock nut tool or a cassette lockring tool instead. Note that this nut is sold individually.

Bolt 3/8-16x.75 g5

Set screw

Capscrew 5/16-18x.625

Skid/Wear Strip

Screw hex 1/4-20x.5