15902 Weber Grill - Overview

This is a Genuine Manufacturer Sourced replacement part used on a variety of Weber Grills. This is a Metal (Aluminum) assembly used to prevent drippings and food particles from marring your deck or patio.

This is an authentic OEM sourced component which is specially designed for Weber grills. It provides an identical replacement for damaged or missing bottom tray rails that were installed on a new unit. The rails allow the bottom tray to slide in and out. Please make sure to refer to the appropriate diagrams for your model for the correct ...Read morereplacement procedure. Keep in mind this high-quality item includes two durable metal bottom tray rails and the hardware to secure them. A wrench set will be needed to perform this repair.

This is an original Weber part manufactured for use with outdoor grills. The control panel plugs with screws fasten the control panel to the side frame. Only two plugs are required to secure the control panel, and this set will include both plugs, and two screws, please note the set is sold individually.

This is a genuine Weber replacement part, sold individually. This part is responsible for controlling the size of the flame on your gas grill. There may be 3 or 4 of these, depending on your grill model. Replacement requires no additional tools. This Control Knob is compatible with the Gas Grills listed below.

This is a manufacturer approved replacement part crossover/carryover tube. It is specially designed for use with Weber gas grills. The purpose of this tube is to allow gas to flow from one burner to another. They also help to secure the burners in place. Over time due to heat and moisture carryover tubes may begin to rust or warp requirin...Read moreg replacement. This would be the time to replace them. This item is made out of metal and it is sold individually.

This genuine OEM sourced replacement burner tube kit is designed for use with Weber grills. These are the burners that the flames would rise from, the kit includes the crossover tube which allows gas to flow from one burner tube to another. These parts are very easy to install with included hardware and instruction sheet. This kit include...Read mores two durable stainless steel burner tubes, one crossover tube and the hardware with the instruction sheet.

This is an OEM replacement part sourced from the Weber manufaturer. The metal hex nut is compatible with rotisseries and grills. This part is often used to secure the burner tube kit within the cookbox with rails. Please refer the the specific manual and diagrams for repair instructions. A wrench may be needed to make the repair. This item is sold individually.

8" X 21 1/2"