1567 - Overview

This is a splash guard and stopper for a garbage disposer. The splash guard is a rubber cover that goes over the sink drain to prevent liquids and food particles from splashing back up into the sink while the garbage disposer is running. The stopper creates a seal on the splash guard and prevents liquids and food from going down the drain...Read more when the garbage disposer is not in use. With normal wear and tear of these parts, they will eventually need to be replaced. Both parts are black in color and approximately 3 inches in diameter, with the splash guard being slightly larger so the stopper can fit inside of it.

The lock washer goes next to the flat washer and is made of metal. It is available as an individual replacement part. This genuine item is supplied by the original equipment manufacturer for use with snowblowers made by Toro and Lawn Boy. A wrench might be helpful during the installation of this part. This item may become broken and will need to be replaced.

This is a genuine Toro replacement part that has been sourced from the original manufacturer to be used with snowthrowers. The metal flat washer is used to disperse pressure put on a part assembly by a nut or bolt across a wider surface area. This item is used with several different models of snowthrowers. It is recommended to review your...Read more model\\\'s part diagram to confirm the washer\\\'s compatibility and usage. The flat washer is priced individually.

A deck wheel that drags, wobbles, or has a flat spot may no longer protect the turf correctly. The smooth roller touches the ground when the mower deck passes over a raised area, helping prevent the blade from cutting deep patches. Check deck level and tire pressure first because poor adjustment can also cause scalping. Match the replacem...Read moreent using the complete mower model and serial number, and compare the bore, width, bracket spacing, and required hardware. Shut off the engine, remove the key, set the parking brake, and disconnect the spark plug before service. Support the deck securely, tighten the fastener properly, and make sure the wheel turns freely.

It is an authentic OEM part which is made for Lawn Boy and Toro riding lawn mowers and garden tractors. This is one of the special bearings that allow wheels to rotate with minimum friction. Unfortunately, over time it may wear out or get damaged eventually requiring a replacement. One durable metal bearing-wheel is included. Make sure to...Read more check the appropriate diagrams for your model for the correct installation of the new component. You will need a wrench set to perform this repair.

The thrust washer is made of metal and goes next to the spring washer. This is a genuine replacement part sourced from the original manufacturer for use with lawn tractors made by Toro and Lawn Boy. This item is available as an individual replacement. During the installation process, a screwdriver might be needed to replace this part. It will need to be replaced if it breaks.

This is an authentic Toro replacement part, sourced from the original manufacturer for use with snowthrowers. The valve is part of the tire assembly and is used to regulate tire pressure by allowing air into the tire and preventing air from escaping. This valve is available as an individual replacement part.