14650-7 General Electric Range - Overview

Diagrams for 14650-7

See every part. Know exactly what you need.

Parts for the 14650-7

$26.39

Light Cover

★★★★★

(10)

Part #WB36X192

This light bulb lens covers the interior light bulb in an oven, range, or stove. No tools are necessary to replace this part. Simply slide off the wire bracket to remove the existing light bulb lens. Disconnect power to your appliance before this repair. It is recommended to check the light bulb while the lens cover is removed in case it ...Read more

Read less

Fluorescent Lamp/Bulb

★★★★★

(2)

Part #F26T8-CW-4

Oven Sensor

Part #WB21X158

This sensor offers 16 ohms of resistance at room temperature, though the resistance increases as the temperature increases.

Leveling Leg

Part #WB2X8248

$37.91

SCREW

Part #WR2X9260

Door Latch Solenoid

Part #WB24X5097

GASKET

Part #WB2X3163

$38.96

HANGER

Part #WB2X3165

SWITCH SOLENOID

Part #WB24X5235

WHEEL DRAWER

Part #WB2M528

ELEMENT 8" 2400W - P1T23F

Part #WG02F05386

$83.89

BODY DRAWER

Part #WB58M64

Common Symptoms of the 14650-7

How this model fails, and the parts that fix it.

Element will not heat

Fixed by
these parts

Show All

Little to no heat when baking

Fixed by
these parts

Show All

Repair Tips From Fixers Like You

See how others fixed this model. Time, tools, difficulty, and steps that lead to victory! View More

oven temperature too low

17 of 19 people found this instruction helpful.

Ryan from Henderson, NV
Easy
Less than 15 mins
Nutdriver

After ordering the proper part with the help of the phone customer service tech, I moved the stove from the wall, unclipped the connector, removed the two screws holding the sensor in place, and removed it. Reversed the above to put it back, and the oven holds perfect temperature.

Was this helpful?

oven would not come up to temperature

14 of 17 people found this instruction helpful.

Clarence from Norwich, NY
Difficult
30 - 60 mins
Nutdriver, Pliers, Screw drivers

Removed sensor from back wall of oven by removing 2 screws from flange. I could not pull the wire-nut connections out through the small hole and thought I would have to pull the whole oven out of the wall to acess the connections from the back so instead I clipped the wires close to the old sensor and connected the new sensor with the sma ... Read more

Read less

Was this helpful?

remove and replace

10 of 24 people found this instruction helpful.

Perry from Flushing, NY
Really Easy
Less than 15 mins

very easy remove the bad bulb install the new one

Was this helpful?