143996708 Craftsman Engine - Overview

This screw, also known as a shoulder bolt, is a genuine OEM replacement part for your lawn mower. This metal screw holds the starter grille in place against the rewing starter on your lawn mower. It requires a wrench to be loosened or tightened.

This is an authentic OEM sourced replacement part, it is specially made for use with lawn and garden equipment. It is a standard hardware which has multiple applications depending on your model, please refer to appropriate diagrams for correct location and use of this item. Please note this high-quality hex head screw is sold individually.

This black OEM fuel cap (1-1/2 ID) is a black plastic cap which attaches to the fuel tank to keep fuel in and keep debris out. If the cap becomes broken due to wear/damage/fatigue there may be a fuel leak, and the part should be replaced. Refer to your make, model and diagrams to ensure this cap is right for you.

This piston ring set is designed to create a tight seal between the piston and cylinder wall, helping restore proper compression and reduce oil consumption in small engines. By improving sealing efficiency, it supports smoother starting, steady power, and reliable overall performance. Ideal for replacing worn or damaged rings, it helps extend engine life and maintain consistent operation.

This is a genuine replacement part sourced from the original manufacturer for use with small engines. The metal hex nut is used to fasten the engine's flywheel to the crankshaft assembly. This item is available as an individual replacement part, please see diagram for related items.

This spark plug cover is supplied directly from the original equipment manufacturer. The rubber and metal component is often used in snowthrower engines, and is sold individually. The spark plug cover is fitted over the spark plug wire connection, providing protection. A screwdriver and pliers may be required for the removal and replacement.

This is an authentic part that is supplied directly from the original equipment manufacturer for Craftsman and Tecumseh pressure washers, lawn mowers, and snow blowers. When pulled, the starter rope engages starter spring causing the engine turn fast enough for the ignition module to generate a spark to ignite the fuel in the cylinder. Th...Read moreis part is made of nylon rope and is sold individually. To install the rope you will need a screwdriver and socket wrench. Turn the starter spring to build tension and recoil the rope inside.

This O-ring is designed for use with small engine carburetors and is made of rubber, meaning over time and further exposure to fuel, it will become brittle and crack. This O-ring is installed within the carburetor and is located between securing screws near the base. If disassembling your equipment to replace this O-ring, it is recommende...Read mored you inspect the other parts to ensure optimal performance and to prevent any leaks. Featuring an inner-diameter of approximately 0.25-inches, the replacement process for this O-ring in your engine will vary, so check the user manual for exact location of this part.

This is an original replacement part manufactured for use with small engines on outdoor power equipment. The starter handle is tethered to the starter rope and used to pull start the engine. This starter handle is sold as an individual replacement part, please see model diagram for associative parts.