143978 Craftsman Engine - Overview

The Fuel Line Clamp is a metal, individually sold part which clamps onto the fuel line, securing it to a port and preventing leaks. Installation is rated as "Easy" by customers and will require pliers and a screwdriver. If broken due to wear/fatigue/damage, there may be a fuel leak and the part should be replaced. Refer to your make, model and diagrams to ensure this is the correct part.

This is a genuine replacement part that has been sourced from the original manufacturer to be used with snow thrower engines from Husqvarna and Toro. The metal screw is used to fasten the fuel tank to the tank mounting bracket. This item is available as an individual replacement part, please note a hex socket wrench may be needed to install this item.

This black OEM fuel cap (1-1/2 ID) is a black plastic cap which attaches to the fuel tank to keep fuel in and keep debris out. If the cap becomes broken due to wear/damage/fatigue there may be a fuel leak, and the part should be replaced. Refer to your make, model and diagrams to ensure this cap is right for you.

This plug is an OEM direct from Craftsman for lawn mowers, tillers, lawn tractors, and chippers/shredders. This plug produces the flare that starts up the fuel in the engine. You will need a deep socket and a wrench to replace this part. This plug is made of plastic and metal. This part is sold individually.

This OEM valve cover gasket, also known as the breather gasket, creates a seal between the breather body and cylinder block in your lawn equipment. Made of flexible plastic, it measures 2 inches by 4 inches. Oil stains or leaks around the valve cover indicate a problem with the gasket. You may also notice a burning smell or ticking noise ...Read morefrom the engine. If the gasket is not replaced, it can lead to severe engine damage and even engine failure. When replacing the gasket, start by turning off your machine and disconnecting the spark plug. Depending on your equipment model and make, you may need to remove components like the air filter or spark plug wires to access the valve cover. Refer to your user manual for guidance. Once you have access to the valve cover, use a wrench or socket to unthread the securing bolts or screws. Then, carefully peel off the old gasket. Please keep in mind that this replacement part is sold individually.

This spark plug cover is supplied directly from the original equipment manufacturer. The rubber and metal component is often used in snowthrower engines, and is sold individually. The spark plug cover is fitted over the spark plug wire connection, providing protection. A screwdriver and pliers may be required for the removal and replacement.

This is an authentic part that is supplied directly from the original equipment manufacturer for Craftsman and Tecumseh pressure washers, lawn mowers, and snow blowers. When pulled, the starter rope engages starter spring causing the engine turn fast enough for the ignition module to generate a spark to ignite the fuel in the cylinder. Th...Read moreis part is made of nylon rope and is sold individually. To install the rope you will need a screwdriver and socket wrench. Turn the starter spring to build tension and recoil the rope inside.